TRENDnet TEW-230APB User Manual page 12

encryption between the station that you connected with, if you
select 64bit in Hex format, you must type 10 values in the
following range (0~F, hexadecimal), or 64bit in ASCII format,
you must type 5 values in the following range (0~9, A~Z and
a~z Alphanumeric). Besides, if you select 128bit in Hex format,
you must type 26 values (0~F, hexadecimal), or 128bit in ASCII
format, you must type 13 values in the following range (0~9,
A~Z and a~z Alphanumeric).
Click on the 802.1x function to authenticate the WEP security with the
wireless devices, select WEP 64bits or WEP 128bits for authentication.
IV. Access Control
Access Control function allows clients whose MAC addresses in the
list will be able to connect to this Access Point. When this function is
activate, there is no wireless clients will be able to connect to the
Access Point unless they are listed in the Access Control list.
17
V. Connection List
This function shows the MAC Address, transmission packet counters,
reception packet counters, and encryted status for each associated
wireless client.
VI. WDS Setting
WDS (Wireless Distribution System) uses wireless media to
communicate with other Aps, click enable WDS to configure the
following setting on this page:
18