Hardware Instalation; Led Indicator; Rear Panel - TRENDnet TEW-230APB User Manual

HARDWARE INSTALATION

LED Indicator

The figure below shows the LED Indicator of the Wireless LAN
Access Point.
Front View
POWER
This indicator lights green when the Access Point receives power.
Otherwise, it turns off.
LAN (Link/ACT)
The indicator lights green when the LAN port is connected to a
100Mbps Ethernet station, the indicator blinks green while
transmitting or receiving data on the 100Mbps Ethernet network.
WLAN (Link)
The indicator blinks green when the wireless station connected to the
AP, the AP is always transmitting or receiving data once a wireless
device is connected, otherwise, the light turns off.
Power LAN WLAN
5

Rear Panel

The figure below shows the rear panel of the Access Point
- +
Rear Panel
Ethernet
Ethernet uplink port with auto-sensing for connecting to either
10/100Mbps Fast Ethernet connections, connect this port to
switch/hub.
Reset
There is two function by pressing the "Reset" button, one is software
reboot and the other is factory reset.
Software Reboot: to reboot the Access Point, press the "Reset"
button.
Factory Reset: to reset the setting back to factory default setting,
press the "Reset" button within 10 seconds, once you press the
button, the LED of the WLAN will turn off and when the
Access Point is ready, the LED will start blinking.
DC Power
Connect the AC Power Adapter to the AP's power jack.
Ether net R eset
6