Stelpro uniwatt UTB0502W Owner's Manual

UTB0502W
UTB1002W
UTB1502W
UTB2002W
UTB
1-844-STELPRO
WWW.UNIWATT.CA
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1. Read all instructions before using this heater.
2. A heater has hot and arcing or sparking parts inside. Do not use
it in areas where gasoline, paint, or flammable liquids are used or
stored.
3. This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. If provided, use handles when moving this
heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains away from heater.
4. To prevent a possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where open-
ings may become blocked.
5. Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
6. This product must be installed by a qualified person and con-
nected by a certified electrician, according to the electrical and
building codes effective in your region and NEC.
The following instructions must be adhered to avoid personal injuries
or property damages, serious injuries and potentially fatal electric
shocks.
7. Protect the heating unit with the appropriate circuit breaker or
fuse, in accordance with the nameplate.
8. Make sure the line voltage (volt) is consistent with that indicated
on the unit's nameplate.
9. This unit must be grounded.
10. Switch off the power at the circuit breaker/fuse before installing,
repairing and cleaning the unit.
11. Make sure the unit is appropriate for the intended use (if needed,
refer to the product catalog or a representative).
12. Do not install the unit where objects or furniture could be damaged
by the heat.
13. Respect distances and positions indicated in the installation
section.
14. If the installer or user modifies the unit, they will be held responsi-
ble for any damage resulting from this modification, and the CSA/
UL certification could be void.
15. When starting up the unit for the first time or after a long period,
it is normal that it produces some temporary odours and whitish
smoke.
16. Do not install on a wall behind a door.
17. Make sure the electrical connections are sturdy and have been
executed correctly. Failure to comply with this directive could
result in a fire.
SAVE THESE INSTRUCTIONS
MATERIAL REQUIRED: Phillips screwdrivers, screws,
twist-on wire connectors, wire strippers.
OWNER'S MANUAL
ELECTRIC BASEBOARD
EN1