Stelpro UNIWATT AZUR UAC 01 Series User Manual
Stelpro UNIWATT AZUR UAC 01 Series User Manual

Stelpro UNIWATT AZUR UAC 01 Series User Manual

Glass front convector

Advertisement

GLASS FRONT CONVECTOR
REPLACEMENT COMPONENT LIST INCLUDED
This unit complies
with CSA
standards
UNIWATT is a line of products manufactured by STELPRO. For more information please contact customer service.
CRÉÉ PAR | CREATED BY:
CRÉÉ LE | CREATED ON:
MIS À JOUR | UPDATED:
TOLÉRANCES SI NON-SPÉCIFIÉES | TOLERANCES IF NOT SPECIFIED
N.DEFFINS
2015-05-14
2015-12-14 / adesmarais
UAC
# PIÈCE | PART #:
UACXX01
DESCRIPTION:
INSUAC0220
UAC
MATÉRIEL | MATER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UNIWATT AZUR UAC 01 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Stelpro UNIWATT AZUR UAC 01 Series

  • Page 1 CRÉÉ LE | CREATED ON: 2015-12-14 / adesmarais MIS À JOUR | UPDATED: DESCRIPTION: UNIWATT is a line of products manufactured by STELPRO. For more information please contact customer service. INSUAC0220 TOLÉRANCES SI NON-SPÉCIFIÉES | TOLERANCES IF NOT SPECIFIED MATÉRIEL | MATER...
  • Page 2: Important Instructions

    If needed, refer to a specialist who will be able to calculate these heat losses and optimize the required capacity or consult the “Online heating calculation” section of the Stelpro website (residential buildings). To heat a large room and to increase your comfort, it is recommended to install several units instead of one.
  • Page 3: Technical Drawings

    TECHNICAL DRAWINGS AND SPECIFICATIONS TECHNICAL DRAWINGS 1 3/16" 30mm 3 9/16" 91mm LENGTH 3/4" 1/4" 1 15/16" 19mm 49mm  7/8" 22mm 1 5/16" 34mm 18 1/16" 458mm 10 15/16" 278.2mm 4"  FRONT 102mm SIDE MIN. SPECIFICATIONS BUILT-IN WITHOUT POWER VOLTAGE LENGTH...
  • Page 4: Installation

    INSTALLATION INSTALLATION CUT OFF POWER SUPPLY AT CIRCUIT BREAKER/FUSE BEFORE PROCEEDING TO THE INSTALLATION. - The bottom of this unit must be installed at least 4 inches (10.2 cm) from the floor and 6 inches (15.2 cm) from any adjacent surfaces (and PVC windows).
  • Page 5: Electrical Connection

    ELECTRICAL CONNECTION & OPERATION ELECTRICAL CONNECTION STANDARD MODELS MODELS WITH 120 V PLUG MODELS WITH 120 V PLUG (À RACCORDEMENT FIXE) (RESIDENTIAL OUTLET) (RESIDENTIAL OUTLET) THIS UNIT IS EQUIPPED WITH A THREE-WIRE GROUNDING THIS PRODUCT MUST BE CONNECTED BY TYPE AC PLUG: A QUALIFIED ELECTRICIAN, ACCORDING TO THE ELECTRICAL AND BUILDING CODES - For safety reasons, the plug can only be inserted into an outlet with...
  • Page 6: Operation

    OPERATION DAY MODE NIGHT MODE HOW TO SET THE DAY TEMPERATURE HOW TO SET THE NIGHT TEMPERATURE By pressing down the top or bottom button, you will enter the setting By pressing down the top or bottom button, you will enter the setting mode indicated by the flashing SUN icon.
  • Page 7: Maintenance

    OPERATION, MAINTENANCE & TROUBLESHOOTING PRECISE ELECTRONIC CONTROL In order to obtain a precise and optimal ambient temperature reading, the unit must operate on a regular basis, i.e. without significant A chrono-proportional electronic thermostat controls this unit with a temperature variation for at least an hour. (This amount of time high degree of accuracy in order to minimize temperature differences increases if a temperature change of more than 4 degrees is requested.
  • Page 8: Limited Warranty

    Moreover, it does not cover the cost of disconnection, transport, and installation. The warranty is limited to the repair or the replacement of the unit or the refund of its purchase price, at the discretion of Stelpro. Any parts replaced or repaired within the warranty period with the written authorization of Stelpro will be warranted for the remainder of the original warranty period.

Table of Contents