Page 1
USER’S gUidE SgH SERiES CeiLing fAn heATer repLACemenT ComponenT LiST inCLUded LISTED This unit complies with CSA and UL standards For further information or to consult this guide online, please visit our website at www.stelpro.com INSSGH1213...
Page 2
If needed, refer to a specialist (industrial and commercial buildings) who will be able to calculate these heat losses and optimize the required capacity or consult the “Online heating calculation” section of the Stelpro Design Web site (residential buildings). To heat a large room and to increase your comfort, it is recommended to install several units instead of one.
Page 3
SpeCifiCATionS ceiling fan heateR VOLTS 240 V WATTS 4000 W AMPeRAGe cOLOR ReD, yeLLOW OR STAINLeSS STeeL WeIGHT 10 Lb / 4.5 Kg TecHNIcAL DRAWINgS 126mm 4,97po 348mm SIDE 13,70po 348mm 13,70po 38mm 1,50po K.O. (22mm) BOTTOM INSSGH1213...
Page 4
inSTALLATion This unit is designed to be installed on the surface of a finished ceiling,. are made while the unit is still hanging from the bracket. (Fig. 4) 7. Remove the back wiring compartment plate and knock down the 7/8 These units require a minimum mounting height of 8 feet (2.44 m) from K.O.
Page 5
MAINTeNANCe n.B. in order for the warranty to be valid, the unit must be do not use cleaning products identified with these symbols: cleaned regularly. Cut off power supply at circuit breaker/fuse before cleaning the unit. Use a soft rag for dusting. When cleaning, use only a damp rag and non-abrasive dish soap.
Moreover, it does not cover the cost of disconnection, transport, and installation. The warranty is limited to the repair or the replacement of the unit or the refund of its purchase price, at the discretion of stelpro. Any parts replaced or repaired within the warranty period with the written authorization of Stelpro will be warranted for the remainder of the original warranty period.
Need help?
Do you have a question about the Spider and is the answer not in the manual?
Questions and answers