Basic Operation; Checking The Xm Signal Strength And Radio; Searching Categories; Accessing Xm Radio Channels Directly - Denon AVP-A1HD Owner's Manual

Basic Operation

1
<SOURCE SELECT>
Either turn
(AMP mode) to select "XM".
:
"Source Select" (vpage 45)
2
To operate using the main remote control unit, set the
remote control unit to the TUNER (
(vpage 77 "Remote Control Unit Operations")
3
[d f]
Use to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
[d f]
• The channel switches continuously when
• XM Radio channels can be preset using the same procedure as for
FM/AM stations (vpage 59, 60 "Presetting Radio Stations (Preset
Memory)" and "Listening to Preset Stations").
• The artist name, song title, category and reception level can be
<STATUS>
checked by pressing .
• The time for which the GUI menus are displayed can be set at
GUI menu "Manual Setup" – "Option Setup" – "GUI" – "Tuner"
(vpage 42).
Checking the XM Signal Strength and
Radio ID
[SAT TU]
or press
1
Either turn
(AMP mode) to select "XM".
2
<STATUS>
Press
display.
) mode.
The display will switch as shown below, depending on the
reception conditions.
Display
GOOD
MARGINAL
WEAK
NO
is pressed and held.
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
<STATUS>
Press
"XM001") is displayed.
5
[d f]
Press
The radio ID is shown on the display.
The strength of both the XM satellite and terrestrial signals can be
checked at GUI menu "Source Select" – "XM" – "Antenna Aiming"
(vpage 49).
<SOURCE SELECT> [SAT TU]
or press
until "SIGNAL" appears on the
GUI Status
Signal strength is good
Signal strength is marginal
Signal strength is weak
No signal
until the channel (example:
and select channel 0 (XM000).
Radio ID

Searching Categories

1
Press o p .
Channel category
2
Use o p to select the category, then use
the desired channel.

Accessing XM Radio Channels Directly

1
[SEARCH]
Press .
2
[NUMBER]
Press then input the channel.
Example: Accessing channel "XM123":
[1] → [2] → [3]
b If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
3
ENTER
Press to set that channel.
Reception switches to the selected channel.
• "LOADING" is displayed while channels or data are being received.
• "XM - - -" is displayed if the selected channel cannot be used.
ui to select