Denon POA-A1HDCI Owner's Manual
  1. Manuals
  2. Brands
  3. Denon Manuals
  4. Amplifier
  5. POA-A1HDCI
  6. Owner's manual
Denon POA-A1HDCI Owner's Manual

Denon POA-A1HDCI Owner's Manual

Power amplifier
Hide thumbs Also See for POA-A1HDCI:
Table of Contents

Advertisement

Quick Links

Download this manual
DENON
POWER AMPLIFIER
POA-A1HDCI
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POA-A1HDCI and is the answer not in the manual?

Questions and answers

Related Manuals for Denon POA-A1HDCI

Summary of Contents for Denon POA-A1HDCI

  • Page 1 DENON POWER AMPLIFIER POA-A1HDCI Owner's Manual...
  • Page 2 FCC requirements. Modification not expressly Do not block any ventilation openings. COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. approved by DENON may void your authority, granted by the FCC, to use Install in accordance with the manufacturer's instructions. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL the product.
  • Page 3 NOTE ON USE I OBSERVATIONS RELATIVES A L'UTILISATION CAUTION: • The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, tablecloths, curtains, etc. • No naked flame sources, such as lighted candles, should be placed on the unit. •...

  • Page 4: Table Of Contents

    ··· .. before using the unit. In the NORMAL connection and Bi-AMP connection operation Change the input mode • Cautions on using mobile phones mode, POA-A1HDCI has acquired THX certification. To play back Change the operation mode · · ·...

  • Page 5: Cautions On Installation

    Cautions on Installation Preparations Note: Before using this unit. the following steps should be followed. according to the situation in which the unit will be used. For proper heat dispersal, do not install this unit in a confined space, such as a bookcase or similar enclosure. ,:;;...

  • Page 6: Part Names And Functions

    12 (mW) 8 (mW) 6 (mW) Power indicator·· . (13) Center channel meter select button (METER) (13) i> Possible output by POA-A1HDCI is up to the rated output. • Power switch (_ON .OFF)····· (13) Center channel level meter . (13) -NI"-...

  • Page 7: Rear Panel

    Rear Panel ~--"1 f,..-------, IseR) (SIll ISBlJ COlD-BROOE- HOT COlD-BRDGE-HOT COlD-BRtOGE- HOT COLD-BRiDGE-HOT = . .. = .. = . . I'onJyJ = . .. = .. = . . = .. = .. = .. = . .. = .. = .

  • Page 8: Preparations

    If the protection circuit is activated again even though there are no problems in the ventilation around the set nor in the connections, the set may be damaged. Turn the power off, then contact a DENON service center.

  • Page 9: Change The Input Mode Change The Operation Mode

    Settings -M·n8 MODE, CONTROL, Operation mode select switch Input select switch must be set before turning the power on. Settings which are changed after powering on will not be registered. In such cases, the (~page : Operates the unit from the AVP-A 1HOCI Use XLR.

  • Page 10: Connecting To An Xlr Input Terminal

    This example shows the connection of an AV sound preamplifier AVP·A1HDCI (sold separately) to Example: 7-channels (NORMAL setting) the unit, CONTROL To operate POA-A1HDCI from AVP-A1HDCI. connect the control link cable. set switch to MOOE "AVP" and then set switch to "1",...

  • Page 11: Settings

    Connecting 2 POA-A1HDCI units to AVP-A1HDCI the AVp·A1HDCI The AVP-A 1 HOCI can be operated when connected to 2 POA-A1HOCI units. Settings Connect the equipment using a control link cable. CONTROL switch of two POA·AIHDCI units to Control link cable (included) "AVP"...

  • Page 12: Settings And Connections

    Settings and Connections .~[.Ij. Set the rear panel "Operation mode select switch" and "Input select switch" according to the connection method. The Operation mode select switch and Input select switch must be set before turning the power on. Settings which are changed after powering on will not be registered. In such cases, the power should be switched off and on again.

  • Page 13: Bi-Amp Connections

    When using speakers that have input terminals for both woofer units and tweeter units. this Example: Bi·Amp connection using. and channels connection outputs one input signal from the two amps on the main unit to each of these units. With this connection the interference between signals for the woofer unit and tweeter unit is Setup each pair channel using the same steps.

  • Page 14: Bridge Connections

    Bridge Connections This connection is used to use two power amps to output opposite phase signals generated from Example: Bridge connection using channels one input signal using two power amp units. By connecting the output side) of the two power amps to the speaker, a larger output than in a Setup each pair channel using the same steps.

  • Page 15: Connecting The External Controller

    Connecting the External Controller Connecting the Power Cord Wait until all connections have been completed before connecting the power cord. When using the following functions, set the CONTROL switch to -EXTERNAL To wall-mounted power outlet lAC 120 V. 60 Hz) In order to fully demonstrate the ability of POA- HDCI.

  • Page 16: Turning The Power On

    Select the channel to display on IFront panel] the channel level meter "" Operations METER..(;;: The indicator of the sel.ected channel meter turns green and the outPlit level the selecte<f chaO/iel is indicated on the meter. Turning the Power On POWER.' .
  • Page 17 • Turn off the power and contact a • Set is damaged. or B 4 - 16 O/ohms • Speaker output connectors: DENON service center. A + B 8 - 16 O/ohms Bi-wiring 4 - 16 O/ohms General Power supply:...
  • Page 18 DENON www.denon.com Denon Brand Company, D&M Holdings Inc. Printed in Japan DOD 511 4608005...
  • Page 19 Hifi Klubben A/S Dali Aile 1, 9610 Noerager, Denmark Tel: 45-96 72 1000 Fax: 45-96 72 10 14 Finland Soundata Oy Hameentle 157 5th floor 00560 Helsinki Finland Tel: +358-(0)9-47693300 Fax +358-(0)9-47693310 DENON FRANCE A division of D&M France SAS Tour Ventose, 2 rue des Bourets, 92156 Suresnes Cedex, France France Tel +33(0)1-41-383230 Fax +33(0)1-41-380110 Germany DENON DEUTSCHLAND A division of D&M Germany GmbH An der Landwehr 19, D-41334 Nettetal, Germany...
  • Page 20 DENON ELECTRONICS (USA), LLC (a D&M Holdings Company) 100 Corporate Drive Mahwah, NJ 07430-2041 (800) 497-8921 (888) 544-8434 Fax DENON REGIONAL SUPER SERVICE CENTERS (Repair only-No parts orders please) PYRAMID AUDIO UNITED RADIO SERVICE AUDIO SERVICES 305 E. Braker Lane 5717 Enterprise Parkway 544 Central Dr., Suite 101...
  • Page 21 Except as specified below. this Warranty covers all defects in material and workmanship in this product occurring during the above warranty periods. The following are not covered by the Warranty: (I) Any product which is not distributed in the U.S.A. by DENON ELECTRONICS (USA). LLC. (2) Any product which is not purchased in ~ = ' _ ' .
  • Page 22 ~ _ : _ ' . If your unit ever needs service. it may be taken or shipped to any authorized DENON service station or D&M CA ADA I C. (if you are uncertain as to whether a service station is DENO authorized.
  • Page 23 DP-L Levee auto Table tournante Au,a cample' DP-F Syntoniseur, amplificateur integre TU, PMA Preamplificateur, preampllflcateur numerique PRA, AVP, DAP, POA, HA Amplificateur de puissance, Preampliflcateur phono Decodeur surround numerique Excluant Ie mecanisme du dlsque dur Serveur / Client de reseau multimedia Le mecanisme du disque dur Contraleur A / V, Recepteur A / V, Recepteur AM / FM AVC, AVR, DRA...

Table of Contents