Dell PowerEdge 860 Hardware Owner's Manual page 21

Table 1-4. System Messages (continued)
Message
The amount of system
memory has changed.
The amount of tested
memory is below the
minimum system
configuration. System
halted!
Time-of-day clock stopped
Time-of-day not set -
please run SETUP program
Timer chip counter 2
failed
Unexpected interrupt in
protected mode
Utility partition not
available
Warning! No micro code
update loaded for
processor 0
Causes
Faulty memory module.
Information only, if you have changed
the memory configuration.
Invalid memory configuration.
Faulty memory module.
Faulty battery; faulty system board.
Incorrect Time or Date settings; faulty
system battery.
Faulty system board.
Faulty or improperly installed memory
modules or faulty system board.
Utility partition is not available on the
hard disk
Micro code update failed.
Corrective Actions
See "Troubleshooting System Memory"
on page 88. If the problem persists, see
"Getting Help" on page 103.
See "Memory Module Installation
Guidelines" on page 68.
See "Troubleshooting System Memory"
on page 88. If the problem persists, see
"Getting Help" on page 103.
See "Troubleshooting the System
Battery" on page 86. If the problem
persists, see "Getting Help" on page 103.
Check the Time and Date settings. See
"Using the System Setup Program" on
page 29. If the problem persists, see
"Troubleshooting the System Battery" on
page 86.
See "Getting Help" on page 103.
Ensure that all memory modules are
properly installed. See "Memory Module
Installation Guidelines" on page 68. If
the problem persists, see
"Troubleshooting System Memory" on
page 88. If the problem persists, see
"Getting Help" on page 103.
Create a utility partition on the boot
hard drive. See the CDs that came with
your system.
Update the BIOS firmware. See "Getting
Help" on page 103.
About Your System
21