Dell PowerEdge 860 Hardware Owner's Manual page 17

Table 1-4. System Messages (continued)
Message
Error: Incorrect memory
configuration. Ensure
memory in slots DIMM1_A
and DIMM1_B, DIMM2_A and
DIMM2_B match identically
in size, speed and rank.
Error: Remote Access
Controller initialization
failure.
Error 8602: Auxiliary
device failure. Verify
that mouse and keyboard
are securely attached to
correct connectors.
Gate A20 failure
General failure
IDE Primary drive 0 not
found
Invalid memory
configuration detected.
Potential for data
corruption exists!
Keyboard controller
failure
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Keyboard fuse has failed.
Manufacturing mode
detected
Causes
The installed memory modules are
not matched pairs.
Faulty or improperly installed RAC.
Loose or improperly connected mouse
or keyboard cable; faulty mouse or
keyboard.
Faulty keyboard controller (faulty
system board).
The operating system is unable to
carry out the command.
Primary drive 0 set as Auto, no disk.
Unsupported DIMMs are installed in
the system, or the memory
configuration is incorrect.
Faulty keyboard controller (faulty
system board).
Loose or improperly connected
keyboard cable; faulty keyboard; faulty
keyboard controller.
Keyboard fuse has failed.
Faulty system board.
System is incorrectly configured.
Corrective Actions
See "Memory Module Installation
Guidelines" on page 68.
Ensure that the RAC is properly
installed. See "Troubleshooting
Expansion Cards" on page 91.
Replace the mouse. If the problem
persists, replace the keyboard.
See "Getting Help" on page 103.
This message is usually followed by
specific information. Take the
appropriate action to resolve the
problem.
Run the System Setup program to
correct the settings. See "Using the
System Setup Program" on page 29.
Replace or reconfigure the DIMMs. See
"System Memory" on page 67 for
memory configuration guidelines, a list
of supported DIMMs, and supported
memory configurations.
See "Getting Help" on page 103.
Ensure that the keyboard is properly
connected. If the problem persists,
replace the keyboard. If the problem
persists, see "Getting Help" on page 103.
Replace the keyboard.
If the problem persists, the system board
is faulty. See "Getting Help" on page 103.
About Your System
17