Removing A Memory Module; Replacing A Memory Module - Dell Latitude E6400 XFR Service Manual

13.1 Removing a Memory Module

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE: If two memory modules are installed, you must remove the top memory module first
to access the bottom memory module.
5. Follow the procedures in Before Working on Your Computer.
6. Remove the bottom access panel (see Removing the
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the
memory module securing clips.
7. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector
until the memory module pops up.
8. Remove the memory module from the connector.

13.2 Replacing a Memory Module

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE: If you are installing two memory modules, you must install the bottom memory
module first.
1. Place the module at a 45-degree angle, and align the notch in the module with the tab on the connector.
NOTE: If the memory module is not installed properly, the computer may not boot. No error
message indicates this failure.
2. Press down on the module until it clicks into place. If the module does not click into place, remove the
module and reinstall it.
Page 37
™
Dell Latitude™ E6400 XFR Service Manual
1 Securing clips (2)
Access Panel).
Bottom
2 Memory module