Wpan (Uwb/Bt) Card; Removing Awpan (Uwb/Bt) Card - Dell Latitude E6400 XFR Service Manual

1. Slide the card into the connector labeled WWAN/FCM.
2. Press the card down and hold it in place.
3. Replace the M2 x 3-mm screw.
4. Connect the white antenna cable to the connector labeled "main" (white triangle), and connect the black
antenna cable to the connector labeled "aux" (black triangle).
5. Replace the Bottom Access Panel (see Replacing the Bottom Access Panel).
6. Follow the procedures in After Working on Your Computer.
7

WPAN (UWB/BT) Card

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE: WPAN is a generic name for Ultra Wide Band (UWB) and Bluetooth® (BT). Insert a
WPAN card only into the slot labeled WPAN/UWB/FCM.
7.1 Removing a WPAN (UWB/BT) Card
1. Follow the procedures in Before Working on Your Computer.
2. Remove the Bottom Access Panel (see Removing Bottom Access Panel).
3. Disconnect the blue antenna cable from the card.
4. Remove the M2 x 3-mm screw. The card pops up at a 45-degree angle.
5. Slide the card out of the card connector on the system board.
Page 27
™
Dell Latitude™ E6400 XFR Service Manual
1 Antenna cable
3 M2 x 3-mm screw
1 WPAN card 2
2 WPAN card
Card connector