Cooking Tips - Dacor Epicure EORS136 Use And Care Manual

Adjusting the Oven Temperature
your oven is equipped with a feature that allows you to
calibrate the temperature inside the oven to match the
display value without the help of a service technician. Due
to various conditions, the actual temperature inside may
vary somewhat from the displayed temperature. the set-
ting may also vary from mode to mode.
warning
Do not adjust the probe or self clean offset temperatures. The
offset for the probe and self clean offsets must remain at 0 for
proper and/or safe operation.
to change the offset temperature:
1. place an oven thermometer inside the oven.
2. check the temperature variance by running the oven
for one hour in each mode at 350°f (except broil
modes). in broil the normal operating temperature is
555°f. take note of the temperature variance in each
mode.
Food Placement
• typically, when baking on two racks, use rack posi-
tions #2 and #4 or #1 and #3. when baking on three
racks, use rack positions #1, #3 and #5.
• turn pans on the racks so that the long sides run left
to right, as you face them.
• when you are cooking a food item that is very heavy,
use the Dacor gliderack oven rack. you can pull it out
further than a conventional rack, making it easier to
check the food, stir, or add ingredients.
• heavier roasting pans and dishes will cook better on
rack position #1.
• when using a baking stone, use rack position #1 for
best results.
• if you put a baking stone on the gliderack oven rack,
instead of one of the standard oven racks, you can
pull the stone out of the oven further, making pizza
easier to remove.
Operating Your Oven

Cooking Tips

3. with the oven off, press and hold the
on the number keypad at the same time. after about
three seconds "Pass" will appear on the display.
4. immediately enter
start. "slCt" (select) will appear on the display.
5. press the key for cooking mode you want to change
the offset for (ConV BaKe, ConV BroIl, Pure
ConV, ConV roast, BaKe or BroIl).
6. enter an offset temperature value from 1 to 35°f (1
to 18 for ovens set to celsius). press the # key after
entering the numeric value if you want the offset to be
a negative (-) value. press # again to toggle the (-)
setting off. note: "edit" appears on the display when
you start to enter the offset value.
7. press start to save the setting.
8. repeat steps 5 and 6 above for any other cooking
modes you need to offset.
9. press CanCel to exit offset mode.
6
5
4
2
3
1
21
0 and # keys
6428 on the number keypad, then