Cavity Preparation; Parts Supplied - DCS DISHDRAWER DD124P5 Installation Manual

Cavity preparation

4
US CA

Parts supplied

Drain hose Drain hose
support (1) joiner (1)
Edge Protector (1)
(if service hole
partition is metal)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest DCS
Authorized Service Agent, or by phone: 1-888-281-5698, or www.dcsappliances.com. DO NOT extend beyond this limit.
If no side partition,
use a brace for
securing.
2" x 4"
Important!
Be sure the edges of the services hole are smooth or covered. If the service hole is through a metal partition
the hole must be protected with the Edge Protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting tab screw locations
Preferred position. If adequate clearance, services hole can be higher to clear toe kick space.
*
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Clamp (1)
Wire clip (2)
Hexagonal
Side flexible
socket (2)
extrusions (2)
(Long & Short)
Moisture
3⁄8"
protection
tape must
(10 mm)
be applied.
max. ø ½
1 " (38 mm)
*
Install Phillips Washer (1)
tabs (2) 16 mm
screws (9)
Top flexible
extrusion (1)
o
90
max.
(450 mm)
*
Moisture Prefinished toe kick (1)
protection White or Black
tape (1)
(to prevent
moisture damage)
n b e l o c
r v i c e s c a
N o t e : S e
s h D r a w e
d e o f D i
e i t h e r s i
11⁄16
17 "
min.
7
(200 mm)
110-120 VAC
max. 15 A
a t e d
r ® .
7⁄8
"