Cavity Preparation - DCS DISHDRAWER DD124P5 Installation Manual

Cavity preparation

18
US CA
Cavity
Drain hose Drain hose
support (1) joiner (1)
Side flexible extrusions (2)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest DCS
Authorized Service Agent, or by phone: 1-888-281-5698, or www.dcsappliances.com. DO NOT extend beyond this limit.
If no side partition,
use a brace for
securing.
2" x 4"
Important!
Be sure the edges of the services hole are smooth or covered. If the service hole is through a metal partition
the hole must be protected with the Edge Protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting tab screw locations
Note: To align drawer front to adjacent cabinetry, the product to counter top clearance can be
increased to 1⁄8"
*
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Clamp (1)
Wire clip (1)
Moisture
3⁄8" protection
tape must
(10 mm)
be applied.
max. ø ½
1 " (38 mm)
*
3 mm).
(
Phillips 16 mm Edge Protector (1)
screws (5) (if service hole
partition is metal)
90 o
*
max.
(450 mm)
Important!
Adjacent cabinetry must not
extend above cavity base
Moisture protection
Washer (1)
tape (1)
(to prevent
moisture damage)
n b e l o c
r v i c e s c a
N o t e : S e
s h D r a w e
d e o f D i
e i t h e r s i
11⁄16
17 "
min.
(200 mm)
110-120 VAC
max. 15 A
a t e d
r ® .
7⁄8
7 "