D-Link DI-824VUP User Manual page 49

Using the Configuration Menu
Advanced > Routing
Static routes can be added if
you require specific routes
within your internal network.
These routes will not apply to
the WAN (Internet) network.
Dynamic Routing
RIP v1
RIP v2
Destination
Subnet Mask
Gateway
Hop
Enable
Hop Count - In a transmission path, each link is terminated at a network device
such as a router or gateway. The number of hops equals the number of routers or
gateways that data must pass through before reaching the destination.
Dynamic Routing Settings allow the VPN Router to route IP
packets to another network automatically. The RIP protocol is
applied, and broadcasts the routing information to other routers
on the network regularly.
By default, it is set to disable. Check to enable (RIPv1 / RIPv2)
protocol.
Protocol in which the IP address is routed through the internet.
Enhanced version of RIP v1with added features such as Au-
thentication, Routing Domain, Next Hop Fowarding, and Subnet-
mask Exchange.
Enter in the IP of the specified network that you want to
access using the static route.
Enter in the subnet mask to be used for the specified net
work.
Enter in the gateway IP address to the specified network.
Enter in the amount of hops it will take to the specified
network.
Select this option for the specified static route to take effect.
49