D-Link DI-824VUP User Manual page 111

Frequently Asked Questions (continued)
How can I setup my DI-824VUP to work with Earthlink DSL or any
PPPoE connection? (continued)
Step 8
Click Apply. When prompted, click Continue. Once the screen refreshes,
unplug the power to the D-Link Router.
Step 9
Turn off your DSL modem for 2-3 minutes. Turn back on. Once the modem
has established a link to your ISP, plug the power back into the D-Link Router. Wait
about 30 seconds and log back into the router.
Step 10
Click on the Status tab in the web configuration where you can view the
device info. Under WAN, click Connect. Click Continue when prompted. You should
now see that the device info will show an IP Address, verifying that the device has
connected to a server and has been assigned an IP Address.
Can I use my DI-824VUP to share my Internet connection provided by
AOL DSL Plus?
In most cases yes. AOL DSL Plus may use PPPoE for authentication bypassing the
client software. If this is the case, then our routers will work with this service. Please
contact AOL if you are not sure.
To set up your router:
Step 1
Log into the Web-based configuration (192.168.0.1) and configure the WAN
side to use PPPoE.
Step 2
Enter your screen name followed by @aol.com for the user name. Enter your
AOL password in the password box.
Step 3
You will have to set the MTU to 1400. AOL DSL does not allow for anything
higher than 1400.
Step 4
Apply settings.
Step 5
Recycle the power to the modem for 1 minute and then recycle power to the
router. Allow 1 to 2 minutes to connect.
If you connect to the Internet with a different Internet Service Provider and want to use
the AOL software, you can do that without configuring the router's firewall settings.
You need to configure the AOL software to connect using TCP/IP.
Go to http://www.aol.com for more specific configuration information of their software.
111