D-Link SECURICAM Network DCS-2100G User Manual page 71

DCS-2100G User's Manual
In this window, enter the settings for the FTP server you wish to record to. Optionally,
you can enter settings for a secondary backup FTP server.
Local FTP server
1st FTP server:
1st FTP user
1st FTP password:
1st FTP remote
Primary FTP
passive mode:
2nd FTP server:
2nd FTP user
password:
2nd FTP remote
Secondary FTP
passive mode:
D-Link Systems, Inc.
The Default port is 21. To connect to an FTP server, it is
port: recommended that you do not change the port number unless
your camera is behind a router. If your camera is behind a router,
you can assign any port number to this field, but you must enable
port forwarding on the router. Please refer to your router manual
for more information on port forwarding.
If you are going to upload snapshots to an FTP server, you will
need to fill in the Domain name or IP address of your external
FTP server such as ftp://dlink.com or ftp://123.123.123.1. (The
server name and IP address will vary depending on the user.)
The following user settings must be correctly configured for
remote access.
Specify the user name to access the external FTP server (ex.
name:
John Smith).
Specify the password to access the external FTP server (ex.
12345).
Specify the destination folder in the external FTP server (ex.
folder:
snapshot).
Passive mode will allow access to an external FTP server if
your camera is behind a router protected by a firewall.
Specify the Domain name or IP address of your second external
FTP server. This field is optional if you have already filled in
the information for the first FTP server.
name:
Specify the user name to access your backup FTP server.
2nd FTP
Specify the user password to your backup FTP server.
Specify the destination folder on your external backup FTP
server.
folder:
Passive mode will allow access to a second external FTP
server if your camera is behind a router protected by a firewall.
Record Snapshots to your FTP Server with Motion Detection
71