Safety warnings Use appropriate protective equipment when working with the sprayer. Never open the sprayer when it is under pressure. Do not expose the sprayer to heat and sunlight. ATTENTION! The water used for the spraying works must be clean, free from sand or other abrasive particles, as they can damage the parts of sprayers and thus lead to a drop in pressure.
Page 15
Symbols Read the instructions before using the product. Use the spray mask when using the sprayer. Wear suitable protective clothing when using the sprayer. Use protective gloves when using the sprayer. Wash your hands after using the sprayer. Keep bystanders away when spraying Do not spray on windy weather.
Specification parameters Tank volume Flow 0,75 l/min Max pressure 0,25 MPa (2,5 bar) Battery type lithium-ion battery Rated voltage 3,7 V Charging current Battery capacity 2500 mAh Working hours 120 min Charging time 180 min Max liquid temperature 40 °C Size 27,5 x 16 x 46 cm Hose length...
Page 18
Flushing the tank It is strictly forbidden to keep the sprinkler near fire or expose the stand to moisture. Never use powder materials or granular materials to spray with this sprayer. Unauthorized opening of the charger case is prohibited. WARNING! When flushing the tank it is recommended that you follow the chemical manufacturer's flushing Instructions carefully for the chemical you are spraying.
Charging ligth indicator 30-70% Charging ligth indicator 70-100% Charging ligth indicator 0-30% Switching on/switching off Before use, remove the tank cap and fill the tank with the chemicals to be used, replace the cap. Push the switch to the ON position and press and hold the switch handle to start use. Release the switch handle to stop the fluid flow.
Page 20
4) Operators should not spray against the wind. 7. After spraying the chemical, it is necessary to add clean water and spray for 2-3 minutes to discharge the remaining chemical from the machine, otherwise it may cause damage to the sprayer. 8.
Page 21
Faults and troubleshooting methods Fault Reason Troubleshooting Motor does not start 1. Battery has no power 1. Battery charging 2. Poor wire connection 2. . Check the connecting wires. 3. Damaged power switch 3. Replace switch. nozzle does 1. The sprayer hole is 1.
Maintenance Cleaning and correct maintenance of the tool is important for both safety and for the service life of the tool. Note: switch off the tool and disconnect it from the power supply (remove the battery) before cleaning and maintenance - risk of electrical shock and accidental starting. Wipe the tool with a cloth moistened with water and a few drops of soap or detergent.
Have your power tool repaired by qualified professionals in our authorized service centers using original spare parts; thus, you will ensure that the power tool remains safe to use. For further information on our Authorized Service Centers, please visit www.villager.eu or an authorized Villager Products store.
EN 61000-6-3:2007+A1:2011+AC:2012 EN IEC 61000-6-1:2019 EN 60204-1:2018 The person authorized for the preparation of technical documentation: Zvonko Gavrilov, address: Villager D.O.O, Bratislavska cesta 5, 1000 Ljubljana. Place / date: Ljubljana, 27.10.2023. Person responsible for the preparation of technical documentation Zvonko Gavrilov...
Need help?
Do you have a question about the BS 7 and is the answer not in the manual?
Questions and answers