Summary of Contents for Happy Beds Croxley Rattan Ottoman Bed 4ft6 Double
Page 1
Croxley Rattan Ottoman Bed - 4ft6 Double Assembly Instructions Important before assembly: Read these instructions carefully before assembling or using the product. Please check the contents of the boxes before attempting to assemble this product. The instructions will have a checklist of parts and fittings. Assemble the product as close to its intended final location/room as possible.
Page 2
These tools are not necessary, but may help to assemble the product. Do NOT use any power tools as this may damage the frame. (Not metal) This product or some parts of this product will be heavy. Please use an assistant when lifting. Never drag or push the pieces across a hard or stone floor as this will cause damage to the joints.
Page 3
Important for Ottoman and other gas lift beds Please follow these final steps to ensure the best experience with your new bed • Please ensure the pistons are fitted to the bed frame. • Please place the mattress on top of the bed frame. •...
Page 6
Step 1: Firstly, fix the hydraulic pump to each hydraulic base as shown in diagram 1.1. Next fix the left and right hydraulic spacer together with the hydraulic base supports on to both side rails using bolts H. Ensure Plastic washers (part L) are used between the Hydraulic spacer (part 6) and the hydraulic base support (parts 18/19) as shown in the image.
Page 7
Step 3: Fix the Headboard(1) and Footboard(2) with the bed frame by Hardware(F). Step 4: Fix the Metal Corner Block(C) by Hardware(G).
Page 8
Step 5: Join together all the bed base parts (11),(12),(13) and (14) using hardware parts S,X & R and also slide part P onto Part 14 before bolting together. Attach the centre rail(15) with Metal Frame by hardware G,X&R.And then attach hardware parts J as shown. Important note: Please assemble follow arrow direction.
Page 9
Step 7: Assemble the bed base on the right & left hydraulic frame starting from'1'to'3'as shown with HardwareH,X,R&W,and fix the support leg (16) to the bed base by Hardware G,X&R as shown . Important note: Do not tighten the bolts yet!, and this assemble must be done by two persons.
Page 10
Step 8: Adjust the bed base making sure that the distance to the footboard is approximately 15mm to above . Tighten all bolts and screws now. 15 m m to above F O O T B O A R D...
Page 11
H YD R AU LIC PU M P STO PPER (LO C K IN ) (LO CK O U T)
Please dispose of all packaging safely. General Care & Maintenance Wipe clean with a slightly damp cloth. Avoid the use of all household cleaners and abrasives. Periodically check all screw & fixings to ensure they are secure. When moving your product, carefully lift into place. Never drag or push the product across the floor as this will cause damage to the joints.
Need help?
Do you have a question about the Croxley Rattan Ottoman Bed 4ft6 Double and is the answer not in the manual?
Questions and answers