Rmon And The Switch - 3Com SuperStack 3C17300 Implementation Manual

RMON and the
Switch
addition, probes record the behavior of your network, so that you can
analyze the causes of problems.
It reduces the load on the network and the management
workstation
Traditional network management involves a management workstation
polling network devices at regular intervals to gather statistics and
identify problems or trends. As network sizes and traffic levels grow,
this approach places a strain on the management workstation and
also generates large amounts of traffic.
RMON, however, autonomously looks at the network on behalf of the
management workstation without affecting the characteristics and
performance of the network. RMON reports by exception, which
means that it only informs the management workstation when the
network has entered an abnormal state.
The RMON support provided by your Switch is detailed in
Table 4 RMON support supplied by the Switch
RMON group Support supplied by the Switch
Alarms A new or initialized Switch has the following alarm(s) defined for
each port:
Percentage of errors over one minute
You can modify these alarms using an RMON management
application, but you cannot create or delete them.
You can define up to 200 alarms for the Switch.
For more information about the alarms setup on the Switch, see
"Alarm Events"
Settings"
Events A new or initialized Switch has Events defined for use with the
default alarm system. See
page 60
When using the RMON features of the Switch, note the following:
After the default sessions are created, they have no special status. You
can delete or change them as required.
The greater the number of RMON sessions, the greater the burden on
the management resources of the Switch. If you have many RMON
sessions, the forwarding performance of the Switch is not affected but
you may experience slow response times from the web interface.
page 60
on and
page 60
on .
"The Default Alarm Settings"
for more information.

RMON and the Switch

Table 4.
"The Default Alarm
59
on