Rmon And The Switch; Rmon Features Of The Switch - 3Com 1000 User Manual

5-26 C 5: A
HAPTER DVANCED

RMON and the Switch

RMON requires one probe per LAN segment, and
stand-alone RMON probes have traditionally been
expensive. Therefore, 3Com's approach has been to
build an inexpensive RMON probe into the Smart-
Agent of each Switch. This allows RMON to be
widely deployed around the network without cost-
ing more than traditional network management.
A problem with stand-alone RMON probes is that
they are passive; able to monitor and report, but
nothing more. Placing probe functionality inside the
network device allows integration of RMON with
normal device management to allow proactive man-
agement.
For example, statistics can be related to individual
ports and the Switch can take autonomous actions
such as disabling a port (temporarily or permanently)
if errors on that port exceed a pre-defined thresh-
old. Also, since a probe needs to be able to see all
traffic, a stand-alone probe has to be attached to a
non-secure port. Implementing RMON in the Switch
means all ports can have security features enabled.
M
ANAGEMENT

RMON Features of the Switch

Table 5-2 details the RMON support provided by
the Switch.
Table 5-2 RMON support supplied by the Switch
RMON Group Support supplied by the Switch
Statistics A new or initialized Switch has one Statistics ses-
sion per port/VLAN.
History A new or initialized Switch has three History ses-
sions on the 100BASE-TX port, backbone port
and Default VLAN:
60-second intervals, 120 historical samples
stored
30-second intervals, 120 historical samples
stored
30-minute intervals, 96 historical samples
stored
Alarms
Although up to 700 alarms can be defined for
the Switch, a new or initialized Switch has four
alarms defined for each port:
Bandwidth used
Broadcast bandwidth used
Percentage of packets forwarded
Errors per 10,000 packets
You can modify these alarms using an RMON
management application, but you cannot create
or delete them.
For more information about the alarms setup on
the Switch, refer to
page 5-28
on page 5-29.
"About Alarm Actions"
and "About Default Alarm Settings"
on