Page 1
THANK YOU We appreciate the trust and confidence you have placed in Defiant through the purchase of this motion security light. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of...
Pre-Installation PLANNING INSTALLATION Before installing the light fixture, ensure that all parts are present. Compare parts with the Hardware Included and Package Contents sections. If any part is missing or damaged, do not attempt to assemble, install, or operate this light fixture.
Installation Determining the mounting Removing the mounting plate location NOTE: This fixture comes with a mounting plate (D) It is pre-assembled on the light fixture (B) for shipping. □ Unscrew the two decorative screws (E) (the screws do not come out of the canopy) connecting the light fixture (B) to the mounting plate (D) and remove the mounting plate (D).
Page 6
Installation (continued) Installing the mounting plate NOTE: If necessary strip 3/8inch of insulation from junction box wires. □ Connect the house ground wire to the ground wire on the mounting bracket using the wire connector installed on the mounting bracket (DD) □...
Installation (continued) Caulking around the light fixture □ Caulk around the mounting plate (D) and mounting surface with silicone sealant (not included). WARNING: Failure to completely caulk around the light fixture’s mounting base could resulting water seepage into the light fixture and/or junction box. Operation Adjusting the lamp heads WARNING: Risk of fire.
Operation (continued) Adjusting the motion sensor detection zone □ Perform a “walk test”: walk in an arc across the front of the motion sensor (C). □ Watch the light. The light will come on indicating motion has been detected. □ Stop, wait for the light to turn off, and then begin walking again.
Controlling the Light with the Hubspace App (continued) Connect your fixture to the Hubspace App □ In the Hubspace app, tap the plus sign “+” in the upper-right corner. □ Scan the QR code located on the included Quick Start Guide. If you are unable to scan the QR code, you can enter the code manually by tapping Enter Code and following the instructions.
Troubleshooting Problem Possible Cause Solution □ □ The light will not come on. The light switch is turned off. Turn the light switch on. □ □ The fuse is blown or the circuit breaker Replace the fuse or turn the is turned off.
Page 11
FCC RESPONSIBLE PARTY Globe Electric 2264 East 6th Street San Bernardino, CA 92410 www.globe-electric.com This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 12
Questions, problems, missing parts? Before returning to the store, call Defiant Customer Service 8 a.m.-7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday 1-877-592-5233 HOMEDEPOT.COM Retain this manual for future use.
Page 13
HOMEDEPOT.COM GRACIAS Agradecemos la fe y la confianza que usted ha depositado en Defiant al comprar esta luz de seguridad por movimiento. Procuramos crear continuamente productos de calidad diseñados para mejorar su hogar. Visítenos en internet para ver nuestra línea completa de productos disponibles que necesita para el mejoramiento de su hogar.
Contenido Contenido ..........14 Herramientas Requeridas ....15 Información de seguridad ......14 Ferretería Incluida ........16 Garantía...........14 Contenido del Paquete ......16 5 años de garantía limitada ....14 Instalación ..........17 Antes de la instalación ......15 Operación ..........18 Hubspace app.........20 Planificación de la Instalación .....15 Especificaciones ........15 Cuidado y limpieza .........21 Análisis de averías .........22...
Antes de la instalación PLANIFICACIÓN DE LA INSTALACIÓN Antes de instalar el aparato de luz, esté seguro que estén todas las piezas. Compare las piezas con la Ferretería incluida y las secciones de Contenidos del paquete. Si cualquier pieza falta o está dañada, no intente ensamblar, instalar ni operar este aparato de luz.
Antes de la instalación (continuación) FERRETERÍA INCLUIDA NOTA: La ferretería se muestra en su tamaño real. ___AA ___BB ___DD ___CC Pieza Descripción Cantidad Tornillo del soporte de montaje Tornillo de montaje Tornillo del soporte de montaje Soporte de montaje con cable a tierra y conector ensamblado.
Instalación Determinación del Instalación del soporte de montaje sitio de montaje NOTA: Esta lámpara viene con un soporte de montaje (D) Está preensamblada en la lámpara (B) para el envío. Desatornille los dos tuercas decorativas (E) (las tuercas no salen del dosel) que conectan la lámpara (B) al soporte de montaje (D) y retire la el soporte de montaje (D).
Operación (Continuación) Instalación de la placa de montaje NOTA: Si es necesario, pele 3/8 de pulgada del aislamiento de los cables de la caja de conexiones. □ Conecte el cable a tierra al cable a tierra en el soporte de montaje usando el conector de cable instalado en el soporte de montaje (DD).
Page 19
Operación (Continuación) Calafateado alrededor de la lámpara □ Calafatee alrededor de (D) y la superficie de montaje con sellador de silicona (no incluido). ADVERTENCIA: Si no se calafatea por completo alrededor de la base de montaje de la lámpara, podría filtrarse agua hacia la lámpara y/o la caja de empalmes.
Operación (Continuación) Adjusting the motion sensor detection zone □ Realice una “prueba de caminata”: camine en un arco a través del frente del sensor de movimiento (C). □ Mira la luz. La luz se encenderá indicando que se ha detectado movimiento. □...
Control de la lámpara con la aplicación Hubspace (continuación) Conecte su lámpara a la aplicación Hubspace □ En la aplicación Hubspace, toque el signo más “+” en la esquina superior derecha. □ Escanee el código QR que se encuentra en la Guía de inicio rápido incluida.
Solución de problemas Problema Posible causa Solución □ □ La luz no se encenderá. El interruptor de la luz está apagado. Encienda el interruptor de la luz. □ □ The fuse is blown or the circuit breaker El fusible está quemado o el is turned off.
Page 23
ENTIDAD RESPONSABLE DE LA FCC : Globe Electric 2264 East 6th Street San Bernardino, CA 92410 www.globe-electric.com Este aparato cumple con la Parte 15 de las Reglas de la FCC. La operación está sujeta a las dos siguientes condiciones: (1) este aparato no puede causar interferencias perjudiciales y (2) este aparato debe aceptar cualquier interferencia recibida, incluyendo una interferencia que pueda causar un funcionamiento indeseado.
Page 24
¿Tiene preguntas, problemas o piezas faltantes? Antes de devolverlo a la tienda, llame a Servicio al Cliente de Defiant de 08 a.m.-7 p.m., EST, Lunes - Viernes, 09 a.m.-6 p.m., EST, sábado. 1-877-592-5233 HOMEDEPOT.COM Guarde este manual para uso futuro.
Need help?
Do you have a question about the 17000046 and is the answer not in the manual?
Questions and answers