Defiant 17000358 Quick Start Manual

Operation
1
Adjusting the bulb holders and motion sensor
WARNING: Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION: Keep the sensor at least 1 in. (25 mm) away
from the bulbs.
CAUTION: Keep bulb holders 30° below horizontal to
avoid water damage and electrical shock.
NOTE: Do not rotate the bulb holders more than 180°
from the factory setting.
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
2
Setting the sensor for testing
NOTE: When the "ON-TIME" dial is turned to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 5 seconds after all motion
is stopped.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
□ Turn the "ON-TIME" dial to the "TEST" position.
□ Turn the "SENS" dial to the "MIN" position.
□ Aim the motion sensor (C) in the general direction of
the area to be covered.
ON-TIME
TEST
HOMEDEPOT.com
Quick Start Guide
MOTION SECURITY LIGHT
SENS
MIN MAX
□ Adjust the placement of the bulb holders A to direct
light towards the desired location.
□ To ensure proper functionality, rotate the motion
sensor (C) so the controls face toward the ground
for wall and eave mount installation.
A
3
Adjusting the motion sensor detection zone
□ Turn on the circuit breaker or fuse and the light
switch.
□ Perform a "walk test". Walk in an arc across the front
of the motion sensor (C).
□ Watch the light. The light will come on and the red
LED will flash indicating motion has been detected.
□ Stop, wait for the light to turn off, and then begin
walking again.
□ Continue this process until the detection zone has
been established.
□ Adjust the sensor up, down, or side to side to change
the motion sensor (C) detection zone.
C
Please contact 1-866-308-3976 for further assistance.
Item # 1011688659
Model # 17000358
A
C