Optional Module Installation - TRENDnet TE100-S1616V Installation Instructions Manual

Optional Module Installation

The switch offers an optional one-port module for fiber or BNC
connection. The fiber module is available in either single or multi-
mode, it supports SC, ST, MT-RJ or VF-45 connector.
The optional module should be inserted into the extension slot
located at the right side of the switch. Port 16X (for TE100-
S1616V) or port 20X (for TE100-S2424V) will be automatically
disabled when optional module is installed. Before installation,
ensure that the power is disconnected. The module is not hot-
swappable. Unscrew the cover plate in the extension slot. Pull out
the cover plate and slide the module in the metal guides slowly.
Once the module is fully seated in the slot, tighten the screws.
User's Guide 23