Introduction; Device Description; Scope Of Delivery; Proper Use - Scheppach PM1200 Translation Of Original Instruction Manual

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the device
on to third parties.

2. Device description

1. Mixing rod (adapter)
2. Mixing rod (with mixing element)
3. Drive shaft
4. ON/OFF switch
5. Fuse for on/off switch
6. Speed control
7. Handle
8. Engine

3. Scope of delivery

Item
1
2

4. Proper use

Its electronic stirrer is designed to mix and stir the
following materials:
• Thin-bodied stirring materials, such as paints, lac-
quers or plaster. (K5)
• More viscous stirring materials, such as glue, paste,
compound or mortar. (K2)
The product may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about
potential dangers.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the prod-
uct.
The product may only be operated with original parts
and original accessories from the manufacturer.
www.scheppach.com
Quantity Designation
2x Stirrer
2x Stirring tool K2 + K5
2x Replacement carbon brushes
1x 19 mm open-ended spanner
1x Open-ended spanner 22 mm
1x Operating manual
GB | 19