Model Assembly - Horizon Hobby Night Radian FT 2.0m BNF Basic with AS3X and SAFE Select Instruction Manual

Model Assembly

Tail Installation
1. Slide the horizontal stabilizer (A) into the slot of the fuselage.
2. Center the horizontal stabilizer and then secure into place with the 4
included pieces of tape (B).
3. Connect the LED connector on the bottom of the horizontal stabilizer.
4. Connect the clevis to the elevator control horn (C) as shown.
Connecting a Clevis
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
1.
2.
3.
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces
are centered. If the control surfaces are not centered, mechanically
center the control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the
length of the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
4.
5.
6.
1
A
TIP
4
TIP
2
B
3
C
EN
5