General Settings - WattBox WB-820-IPVM-12 Installation Manual

General Settings

Use the below settings to take advantage of the WattBox's basic functions and
notifications.
Outlet Options
Enter the Outlet Name, Mode, and Power on
Delay.
When configuring Power on Delay, make
sure the first device in the network
topology powers on first. Make sure the
first device has enough time to power on
before the next device in the topology
powers on.
For example, the Modem's Power on Delay
is 1 second, the router's Power On Delay is
60 seconds, and the Core switch's Power
on Delay is 90 seconds.
Configure the Outlet Mode to Network Device (Reset Only) for all network
Pro Tip: -_
devices to avoid outages caused by devices accidentally being powered off.
IP Settings
Select DHCP (default) or Static. Static allows you to designate an IP address,
Subnet Mask, Device Gateway, and DNS Server for the WattBox.
Use DHCP and give the WattBox a MAC (DHCP) Reservation to avoid
Pro Tip: -_
IP conflicts or connection loss in case the IP scheme changes.
16