Led Indicators - WattBox WB-820-IPVM-12 Installation Manual

LED indicators

The below chart describes each LED status.
Green
(Solid)
Internet Green
(Flashing)
Red
Green
(Solid)
System
Status
Red (Flash-
ing)
Green
Auto
Reboot
Off
Green
Safe
Voltage Red
Off
Green
Surge Pro-
tected
Off
Green
Grounded
Off
10
All hosts are communicating with the WattBox.
At least one (not all) sites / IP addresses are communicating with
the WattBox.
None of the hosts are communicating with the WattBox.
WattBox is operating normally.
Firmware is being updated. The WattBox interface is inaccessible
during the update.
Auto reboot is enabled. WattBox will power cycle outlets that are ON
when communication with the assigned hosts is lost. Note: outlets
that are OFF will not power cycle.
Auto Reboot is Disabled, no power cycle will occur when com-
munication with the assigned host is lost.
Safe voltage is enabled. The current incoming AC voltage is safe for
operation.
Incoming AC voltage is not safe. Outlets have been turned off to pro-
tect the equipment.
Safe voltage is disabled.
WattBox is powered on and outlets are protected.
The WattBox is not powered on, or the MOVs have opened removing
power from the outlets.
Incoming AC outlet is grounded.
Incoming AC outlet is not grounded and requires inspection by an
electrician.