risK OF eLectric shOcK
DO nOt Open
DO nOt expOse this unit tO rain Or mOisture
The lightning flash with an arrowhead
symbol, within the equilateral triangle, is
intended to alert the user to the presence
of uninsulated "dangerous voltage"
within the product's enclosure that may
be of sufficient magnitude to cause an
equilateral triangle is intended to alert
the user to the presence of important
operating and maintenance (servicing)
instructions in this owner's manual.
** SEE BOTTOM OF APPARATUS FOR
GRAPHIC SYMBOLS **
• Do not use the unit in places that are extremely
hot, cold, dusty, or humid.
• The ventilation should not be impeded by
covering the ventilation openings with items such
as newspaper, table-cloths, curtains, etc.
• When connecting or disconnecting the AC power
adapter, grip the plug and not the cord itself.
Pulling the cord may damage it and create a
• When you are not going to use the unit for a
long period of time, disconnect the AC power
• No naked flame sources such as lighted candles
should be placed on the AC power adapter and
• Leave a minimum of 10cm around the apparatus
• Attention should be drawn to the environmental
aspects of battery disposal.
• Use of apparatus in moderate climates.
• When left in a heated room where it is warm and
damp, water droplets or condensation may form
inside the unit. When there is condensation inside
the unit, the unit may not function normally. Let
the unit stand for 1 to 2 hours before turning the
power on, or gradually heat the room and let the
BRC3087 ENG IB.indd 2
SERVICING TO QUALIFIED SERVICE PERSONNEL.
FILLED WITH LIQUIDS ON OR NEAR THIS UNIT.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED MAY RESULT IN HAZARDOUS
CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE.
This product contains a low
power laser device.
unit dry before use.
Rating Plate Location
• The rating plate is located at the bottom of
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
– Connect the equipment into an outlet on a
circuit different from that to which the receiver is
– Consult the dealer or an experienced radio/TV
technician for help.
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
SERVICEABLE PARTS INSIDE. REFER
WARNING: TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
MOISTURE. DO NOT PLACE OBJECTS
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM.