Table of Contents
Advertisement
OPERATING INSTRUCTIONS
APP SETUP
Download the Bromic Smart-Heat App from the Apple App Store
or Google Play Store. When opened, the Bromic Smart-Heat App
will prompt you to register an account before guiding you through
the configuration of your site. Note that each Smart-Heat Control
requires its own setup. After your site has been configured, you
may configure and control multiple controllers.
Initial pairing of a controller must be done using a Bluetooth connection. Therefore, you must
remain within 10m of the controller until setup is complete. Bluetooth operation range may
vary depending on site conditions and devices, it is recommended to operate within 10m
(30ft) of the controller at all times. Wi-Fi communication is the recommended method and
will enable additional features not available with a Bluetooth connection.
REGULAR USE
After your site has been configured, you may use the Bromic Smart-Heat App to operate
all controllers within the site. If the control is connected to Wi-Fi, you will also gain access
to additional features, such as zoning and scheduling the operation of your Bromic heaters.
Zones may also be used to reorder your appliances by adding the appliances in the exact
order you wish them to be displayed.
The menu may also be used to perform various functions such as:
• Managing site configuration.
• Managing site access with mulltiple users.
• Viewing heater usage.
• Calculating heating costs.
When a Wi-Fi configured control loses connection to the network, it will automatically revert
to a Bluetooth connection until the network connection is restored. This may require a wait
time of 3 minutes.
Bluetooth operation is only possible on one smart device at a time. When the app is open on
multiple smart devices, the connection will automatically transfer to available devices if the
connected device exits the app, closes the app or when the screen is locked.
MAINTENANCE
This control has no serviceable parts inside and, therefore, does not require maintenance
after initial installation. It is recommended to ensure your Bromic Smart-Heat App is up
to date. If your control is not functioning, please refer to the troubleshooting table in this
manual. If your control appears damaged, discontinue use immediately and contact your
supplier. An isolation switch or circuit breaker must isolate all live circuits before
conducting an inspection or servicing connected appliances.
If issues occur with the operation of the Bromic Smart-Heat App, please refer to the
troubleshooting section in this manual. If you are experiencing difficulties with
troubleshooting, please refer to the following instructions to reset a Smart-Heat Control
using the Bromic Smart-Heat App.
Controller reset – This can only be done using BLE & while connected to the controller. To
reset a controller, delete it either from the appliance list or through the site configuration
menu. Then, reconfigure the controller onto the site, ensuring that you are within 10m of
the controller to maintain Bluetooth connection.
27
bromic.com
Play Store
App Store
Advertisement
Table of Contents
Need help?
Do you have a question about the Smart-Heat Control On/Off 1 CH and is the answer not in the manual?
Questions and answers