replaced by the manufacturer, its service
agent or similarly qualified person(s) in
order to avoid a hazard.
Do not operate the iron with a damaged
cord, or if the iron has been dropped or
damaged and if there are visible signs of
damage, or if it is leaking. To avoid the risk
of electric shock, do not disassemble the
iron, but telephone Morphy Richards for
advice. Incorrect reassembly can cause a
risk of electric shock when the iron is
used.
Special instructions
If your iron does not work, check the
following points:
Has the temperature control been set to
the required temperature? Is the plug in its
socket? Is the plug itself or the socket
faulty? (Check by plugging in another
appliance).
WARNING:
When not in use, your iron
should never be placed flat and left on an
ironing board.
To prevent damage to the textile being
ironed, follow the temperature guide
carefully. (Test the inside of the hem of the
garment).
When ironing is complete, remove the
plug from the socket, empty any
remaining water from the tank, and allow
to cool before storage.
If you drop or severely knock your iron,
this could cause internal damage even if
the outside appears alright. Have it
checked by a qualified electrician.
It is recommended that you use up one
beaker of water by operating your iron's
steam and steam boost functions before
ironing any clothes as some dripping may
occur while your iron's steam system is
activated.
Electrical Requirements
Check that the voltage on the rating plate of
your appliance corresponds with your house
electricity supply which must be 230V A.C.
(Alternating Current).
If the socket outlets in your home are not
suitable for the plug supplied with this
appliance, the plug should be removed and
the appropriate one fitted.
WARNING:
The plug removed from the
mains lead, if severed, must be destroyed, as
a plug with a bared flexible cord is hazardous
if engaged into a live socket outlet.
WARNING:
This appliance must be earthed.
7
Need help?
Do you have a question about the TURBO STEAM Dualzone and is the answer not in the manual?
Questions and answers