Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment
can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or
serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are attached to the equipment.
Summary of Contents for Trane Symbio 700BAYOPTN001 Series
Page 1
Installation Guide Symbio™ 700 Indoor Options Module Model Number: Used With: BAYOPTN001* Foundation™ with Symbio™ 700 Controls SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
(HCFCs). Not all refrigerants containing these compounds bump cap, fall protection, electrical PPE and arc have the same potential impact to the environment. Trane flash clothing). ALWAYS refer to appropriate advocates the responsible handling of all refrigerants.
Page 3
This document and the information in it are the property of Trane, and may not be used or reproduced in whole or in part without written permission. Trane reserves the right to revise this publication at any time, and to make changes to its content without obligation to notify any person of such revision or change.
General Information Inspection This kit is required when adding an electric heat accessory kit and condensate overflow switch kit. 1. Unpack all components of the kit. The option module operates with the Symbio™ 700 in the 2. Check carefully for shipping damage. If any damage is condenser to provide electric heat logic control.
General Information Parts List Figure 1. Kit contents Item Description Item Description Options module IMC communication harness Screws Wire tie Information label ACC-SVN294A-EN...
Installation WARNING 5. On the options module, set the address rotary switches to 75. This is required to integrate the options module Hazardous Voltage! with the Symbio™ controller. After installation is Failure to disconnect power before servicing could complete, the Symbio 700 UC configuration will need to result in death or serious injury.
Page 8
For more information, please visit trane.com or americanstandardair.com. Trane and American Standard have a policy of continuous product and product data improvement and reserve the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.
Need help?
Do you have a question about the Symbio 700BAYOPTN001 Series and is the answer not in the manual?
Questions and answers