Icom IC-4SA: IC-4SE: Instruction Manual page 2

- described at right appears during
FOREWORD
This instruction manual explains basic operation of the
IC-4SA/SE UHF FM TRANSCEIVER. When you require
additional information, refer to a separate sheet called
"Tech Talk," available from your nearest Icom Dealer or
Service Center.
USE IN THE NORMAL CONDITION
If one of the function guides
operation or when first applying
power, the transceiver may not
operate as explained in this instruc-
tion manual.
One of these guides
At that time, the transceiver should be set to normal
conditions as follows: |
1) Turn power OFF.
2) While pushing [LIGHT] and [V/M], turn power ON.
e Be sure the function guide indicator disappears.
FIRST APPLYING POWER
If the transceiver seems to malfunction when first applying
power, the internal rechargeable backup battery may be
exhausted. This condition may occur if the transceiver is
operated more than 1 week after the attached battery pack
is exhausted.
At this time, the transceiver should be reset as follows:
1) Connect the wall charger to the top panel. (Asia version:
install batteries into the battery case.)
2) Push and hold [MONI- [MONITOR] [VOL]
TOR] and [LIGHT] = AS
then rotate [VOL] to tl 210)
turn ON power.
<— [LIGHT]
3) Turn OFF power, then
wait until the battery
pack is charged. (Not
applicable to Asia
version)