Scanning Operation; Skip Function - Icom IC-4SA: IC-4SE: Instruction Manual

(2) SCANNING OPERATION
Scan starts
1) Set the transceiver in the desired mode using [V/M] :
- VFO mode for VFO scan.
- MEMORY mode for memory scan.
2) Rotate [SOL] until noise is muted.
3) Push [FUNC] then push [C] to start a scan.
4) When you wish to change the scanning direction down-
wards or upwards, rotate the tuning control.
5) When a signal is received, scanning stops for 10 sec.
elf the signal disappears while scanning pauses,
scanning resumes after approx. 2 sec.
eScanning can be manually resumed by rotating the
tuning control.
6) To cancel scanning, push [C] or [V/M] 2 times.
RELATED FUNCTIONS 5
(3 FREQUENCY SKIP FUNCTION
then
While scan pauses The frequency is programmed.
1) Start VFO scan:
- While in VFO mode, push [FUNC] then push [C].