Korg microKORG2 Owner's Manual page 106

microKORG2
EFFECT, EQ section - DELAY
Tape Echo
A delay that distorts and modulates the pitch of the signal like a tape machine.
Pitch Shift
A delay that shifts the signal up or down.
Reverse
A delay that plays backwards.
LoRes
A delay that lowers the sample rate of the signal.
1. Effect Type (Type) Stereo/Ping Pong/Tape Echo/Pitch Shift/Reverse/LoRes
2. Effect Type-specific parameter
Stereo: N/A (---)
Ping Pong: Stereo Width (Width) [0...127] (CC#115)
Adjusts the mix of the ping pong delay outputs to create a left-to-right bouncing effect. Turning
the knob right increases the width of the bouncing effect.
Tape Echo: Instability (Insta) [0...127] (CC#115)
Adjusts how intense the tape simulation is. Turning the knob to the right will make the delay less
stable.
Pitch Shift: Shift Mix (Shift) [-63...0...63] (CC#115)
Shift Mix: Adjusts how much pitch shifted signal is mixed into the delay feedback and output.
Turning the knob to the right of right and left of center will increase the amount of plus and minus
one octave pitch shifted signal relative to the unshifted signal, respectively.
Reverse: N/A (---)
LoRes: Reduction (Reduct) [0...127] (CC#115)
Adjusts the amount of sample rate reduction within the delay. Turning the knob to the right will
reduce the sample rate.
3. Time ["Bpm Sync" Off: 0...127 / "Bpm Sync" On: 1/64, 1/32, 1/24, 1/16, 1/12, 3/32, 1/8,
1/6, 3/16, 1/4, 1/3, 3/8, 1/2, 3/4, 1/1] (CC#13)
Sets the amount of time the input signal will be delayed before being output. Turning the knob to the
right will increase the delay time.
4. Depth [0...127] (CC#113)
Sets the input level of the delay, affecting how intense the effect is. Turning the knob to the right
increases the input level.
5. Low Cut [0...127] (CC#114)
Adjusts the cutoff frequency of the high-pass filter. Sounds and harmonic components below the cut-
off frequency will be attenuated. Turning the knob to the right will increase the cutoff frequency.
106