Kraus Millennium MIL-1202 Installation Instruction

Single lever washbasin mixer

Download this manual

Dear Valued Customer,

Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere

hope that you are completely satisfied with your new purchase. We welcome any questions or comments

you may have and look forward to assisting you in the future.

Sincerely,

Kraus customer service department.

1. Unpack your new product and ensure that all the parts are contained in the packaging.

Keep the product in its original box until you ready to install it.

2. Shut off the water supply if replacing a previously-installed faucet.

3. Observe all plumbing and building codes in your area.

4. It is recommended that installation of the product be done by a professional plumber.

Product Description and Measurements

Millennium Series

Installation Instruction

Single Lever Washbasin Mixer

Thank You

Prior To Installation Steps

1-800-775-0703; or visit our website at www.

MODEL-MIL-1202

kraususa.com.

Need help?

Do you have a question about the Millennium MIL-1202 and is the answer not in the manual?

Page 1 Thank You Dear Valued Customer, Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere hope that you are completely satisfied with your new purchase. We welcome any questions or comments you may have and look forward to assisting you in the future.
Page 2 MODEL-MIL-1202 Installation Code Parts List Quantity Spout Main mixer Joystick Handle Hose O-ring Lock washer (rubber) Lock washer (brass) Screw pole Do not disassemble the main body, as it has been installed & commissioned correctly & precisely before leaving the factory. To avoid the faucet from jamming, DO flush the water pipe before installation.
Page 3 MODEL-MIL-1202 Installation Step 1 Step 2 Front Side Front Side Spout Spout Main Body Main Body A: Insert spout into the main base/body Step 4 Step 3 Back Side Back Side Spout Spout Alley key Security Screw Decorative Cup Main Body Main Body A: Once the spout is securely inserted into the main base/body A: Using an alley key, tighten the security screw.
Page 4 MODEL-MIL-1202 Installation Spout 3’’ 3 3/4’’ Lower Body 2’’ Make sure the installation holes are in the correct size. Install the lavatory and pop-up waste as shown in the drawing. Connect the main body and water supply pipe with water inlet pipe Usage, Cleaning &...