Related Manuals for AUTOLIFT i-swim 4
Summary of Contents for AUTOLIFT i-swim 4
- Page 1 FIXED POOL LIFT FOR DISABLED PEOPLE DEVICE i-swim 4 MODEL ORIGINAL INSTRUCTIONS REVISION 2023 YEAR...
-
Page 2: Table Of Contents
POOL LIFT DEVICE INDEX i-swim 4 MODEL GENERAL WARNINGS ........................3 MANUFACTURER IDENTIFICATION ....................3 MARKING ............................3 DECLARATION OF CONFORMITY ....................4 IDENTIFICATION OF PERSONNEL ....................5 STRUCTURE AND USE OF THE MANUAL ..................6 SAFETY - GENERAL RULES ......................7 DESCRIPTION OF PARTS ......................... -
Page 3: General Warnings
DEVICE WARNINGS i-swim4 MODEL MANUFACTURER IDENTIFICATION AUTOLIFT SRL Via Trentin 8 – 46020 Pegognaga (MN) - Italy Tel. +39 0376 550375– info@autoliftsrl.com MARKING The machine is manufactured in accordance with the relevant and applicable EU directives applicable on the date of placing into service, specifically Directive 2006/42/EC and related therefore the CE marking is affixed to the identification plate which includes compliance with Regulation (EU) 2017/745 as a "medical device"... -
Page 4: Declaration Of Conformity
Medical devices - Application of risk management to medical devices. (Legal) person in charge of establishing and safekeeping the Technical Construction File with reference to Annex VII Directive 2006/42/EC. TECHNICAL OFFICE - AUTOLIFT SRL Via Trentin, 8 – 46020 Pegognaga (MN) - Italy Pegognaga (MN), lì____________... -
Page 5: Identification Of Personnel
In addition to the duty to carefully follow the instructions contained in this manual, operators are obliged not to use the lift and to report to their direct supervisors or, in their absence, directly to the manufacturer AUTOLIFT srl, any deficiencies or potential dangerous situations that may occur. -
Page 6: Structure And Use Of The Manual
If in doubt about the correct interpretation of the instructions, please get in touch with the technical department of AUTOLIFT srl for clarification. This manual is an integral part of the lift and must be kept with the utmost care by the purchaser so that operators can easily access it at all times. -
Page 7: Safety - General Rules
POOL LIFT DEVICE WARNINGS i-swim4 MODEL SAFETY - GENERAL RULES OPERATORS MUST READ THIS INSTRUCTION BEFORE USING THE LIFT. The operating personnel must be in perfect psycho-physical condition. Never bring your hands close to moving parts. Pay attention to the signs attached to the lift. Do not delete, remove or modify existing security systems. -
Page 8: Description Of Parts
POOL LIFT DEVICE DESCRIPTION i-swim4 MODEL DESCRIPTION OF PARTS 1. Armrest 2. Remote control 3. Seatbelt 4. Seat 5. Removable footrest 6. Protective cover 7. Battery 8. Control unit 9. Upper arm 10. Actuator 11. Lifting arm 12. Fixed column 13. -
Page 9: Overall Dimensions
POOL LIFT DEVICE DESCRIPTION i-swim4 MODEL OVERALL DIMENSIONS Configurations The seat can be adjusted vertically up to 150 mm. Pag. 9 di 40... -
Page 10: Technical Data
POOL LIFT DEVICE DESCRIPTION i-swim4 MODEL TECHNICAL DATA Construction material Aluminium / Stainless steel Casing material Supply voltage 24 V d.c. Battery capacity 2,9 Ah Battery autonomy 50 lifting cycles Degree of protection IP44 Ambient temperature +5°C ÷ +40°C Total weight of the lift without load 85 kg Maximum load 180 kg... -
Page 11: Intended Use
POOL LIFT DEVICE DESCRIPTION i-swim4 MODEL INTENDED USE The lift, located at the edge of the pool, must only be used for the positioning of disabled persons inside the pool and for their exit. The installation of the pool lift must be carried out by an authorised operator. The lift can be operated independently by the disabled person or by an accompanying person using the remote control. -
Page 12: Safety Devices
POOL LIFT DEVICE SECURITY ALERTS i-swim4 MODEL SAFETY DEVICES The following safety devices are fitted to the lift. Emergency stop. Safety belt. IT IS FORBIDDEN TO DELETE, REMOVE OR MODIFY EXISTING SECURITY SYSTEMS. Pag. 12 di 40... -
Page 13: Signals
POOL LIFT DEVICE SECURITY ALERTS i-swim4 MODEL SIGNALS IT IS FORBIDDEN TO ALTER/REMOVE THE APPLIED MARKINGS. Pag. 13 di 40... -
Page 14: Ppe
POOL LIFT DEVICE P.P.E. i-swim4 MODEL Use customised protective equipment to the extent necessary or required by relevant legislation. Personal protective equipment (PPE) is equipment intended to be worn by workers to protect them from the specific risks of the activity they are carrying out. P.P.E. -
Page 15: Residual Risks
POOL LIFT DEVICE RESIDUAL RISKS i-swim4 MODEL RESIDUAL RISKS Despite the fact that the protective measures integrated into the design of the lift, including additional protective measures, have been taken, the following residual risks remain. Risk of the user falling: during positioning in the water and lifting, the user must position himself on... -
Page 16: Storage And Stowage Of The Lift
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL RECEPTION AND CONTROL On receipt of the lift, carry out the following checks: Check that the delivery corresponds to the order specifications and the transport document. Check that the packaging is intact and that there are no parts damaged or broken during transport. Carefully check that the machines have not been damaged during transport or that certain parts have not been removed and/or tampered with. -
Page 17: Handling
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL HANDLING Handling of the packed lift must be done by means of transpallet, forklift, etc. The equipment used for safe handling must have an adequate load-bearing capacity. HANDLING PERSONNEL MUST WEAR SAFETY SHOES. ENSURE THAT NO UNAUTHORISED PERSONS ARE WITHIN RANGE OF THE LIFTING/MOVING MACHINE (TROLLEY, PALLET TRUCK, ETC.) DURING LIFTING, TRANSPORT AND HANDLING OPERATIONS. -
Page 18: Positioning
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL PLACEMENT The lift is supplied in parts to be assembled according to the following instructions. Two employees are required for the assembly of the parts. Personnel opening the packaging must wear safety shoes with iron toe cap, non-slip sole, and suitable gloves. - Page 19 POOL LIFT DEVICE INSTALLATION i-swim4 MODEL Drilling and installation of columns The anchoring system is carried out by means of small columns inserted in the pavement. • Place the lift at the pool's edge in the established final position. • Mark the 4 fixing points.
-
Page 20: Seat Installation
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL SEAT INSTALLATION • Remove the seat from its packaging. • Slide it into the vertical tube. • Insert and tighten the two screws (A) to 50Nm. ADJUSTING THE SEAT IN HEIGHT In order to better adapt the lift to the height of the disabled person, it is possible to adjust the height of the seat. -
Page 21: Panel Installation
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL INSTALLATION OF THE PHOTOVOLTAIC PANEL Remove the four upper plastic rivets (A). Remove the plastic cable grommet rivet (B). Lower the lift to leave space for internal manoeuvring. Position the panel with the pre-assembled cable oriented as shown in the figure. - Page 22 POOL LIFT DEVICE INSTALLATION i-swim4 MODEL Lower the cable onto the vertical upright as shown in the figure and secure it with self-locking plastic ties. Remove the plug from the control unit and insert the jack (D). THE ACCESSORY ACTS AS A CHARGE MAINTAINER. A FULL CHARGE TAKES AT LEAST 25 HOURS.
-
Page 23: Conversion To Left-Hand Version
POOL LIFT DEVICE INSTALLATION i-swim4 MODEL TRANSFORMATION TO THE LEFT VERSION 1) Fairing disassembly Remove the 2 reusable lower front rivets (A) by pushing the centre pin of the rivet with a screwdriver. Remove the six side screws (3+3) (B). Extend the lower base (red arrows) and slide the entire fairing to the rear (blue arrows). - Page 24 POOL LIFT DEVICE INSTALLATION i-swim4 MODEL 2) Replacement and reassembly of joint components Unscrew nut (A) Unscrew screw, spacer, washer and nut (B) Remove connecting bracket (C) and replace with bracket part no. W8040226 (optional) on the opposite side (D). Tighten the 4 screws (E) to 15 Nm.
- Page 25 POOL LIFT DEVICE INSTALLATION i-swim4 MODEL Move the upper arm (H) to the other side of the base (I) and secure it by means of the screw (L) and spacer (M). Rotate the column by 180° and tighten the nut (N) until the axial play is zero, leaving the manual movement of the column free.
- Page 26 POOL LIFT DEVICE INSTALLATION i-swim4 MODEL AT THE END OF THE OPERATION, REASSEMBLE THE FAIRING BY PROCEEDING BACKWARDS. Pag. 26 di 40...
-
Page 27: Control Panel And Remote Control
POOL LIFT DEVICE i-swim4 MODEL CONTROL PANEL AND REMOTE CONTROL On the machine are present: A. Push-button panel on the control unit to be used only by an attendant and/or supervisor in emergency situations and for emergency ascent or descent operations only. B. - Page 28 POOL LIFT DEVICE USAGE i-swim4 MODEL In normal operation, the display shows the remaining DISPLAY battery charge. If the emergency button (A) is pressed, the orange STOP LED (B) lights up and the machine stops. An accompanying person and/or a supervisor may only press the emergency button.
-
Page 29: Operations Before Use
POOL LIFT DEVICE USAGE i-swim4 MODEL OPERATIONS BEFORE USE ALWAYS OBSERVE THE INTERNAL SAFETY PROCEDURES ISSUED BY THE USER ORGANISATION. IN THIS CHAPTER'S DESCRIPTION, NUMERICAL REFERENCES TO DEVICES ARE TO BE FOUND IN CHAPTER 9.1 ABOVE. Before using the lift, the person in charge of positioning must check: 1. -
Page 30: Description Of Use
POOL LIFT DEVICE USAGE i-swim4 MODEL DESCRIPTION OF USE REFER TO CHAPTER 2.1 OF THIS MANUAL FOR THE NOMENCLATURE OF THE LIFT. The user must reach the edge of the pool by means of their wheelchair and position themselves near the lift. CHECK FOR THE ABSENCE OF OBSTACLES THAT MAY INTERFERE WITH UPWARD-DOWNWARD MOVEMENTS. - Page 31 MODEL To ascend from the tank, the user must proceed by reversing the steps described above. THE SEAT AS SUPPLIED BY AUTOLIFT SRL IS EQUIPPED WITH WATER DRAINAGE HOLES MADE IN SUCH A WAY AS NOT TO IMPAIR ITS ROBUSTNESS.
-
Page 32: Cleaning
POOL LIFT DEVICE CLEANING i-swim4 MODEL CLEANING The lift must be cleaned manually with a cloth moistened with non-aggressive detergent (e.g. HACCP multi- purpose environmental cleaner Amuchina) and then rinsed with a cloth moistened with water. DO NOT USE AGGRESSIVE CLEANING AGENTS DO NOT USE WATER JETS OR STEAM CLEANERS BEFORE CARRYING OUT ANY CLEANING OPERATION, STOP THE MACHINE... -
Page 33: Maintenance
POOL LIFT DEVICE MAINTENANCE i-swim4 MODEL MAINTENANCE ALL ORDINARY AND EXTRAORDINARY MAINTENANCE WORK MUST BE CARRIED OUT BY SPECIALISED TECHNICAL PERSONNEL (SEE CHAPTER 1.4). BEFORE CARRYING OUT ANY WORK ON ELECTRICAL PARTS AND ELECTRICALLY DRIVEN MOVING PARTS, THE BATTERY MUST BE REMOVED FROM THE CONTROL UNIT. - Page 34 POOL LIFT DEVICE MAINTENANCE i-swim4 MODEL Place the battery (A) vertically on the wall bracket (B). Green light (C) indicates that the charger is correctly connected to the power supply (100- 240 V AC). Orange light (D) indicates that the battery is being charged.
-
Page 35: Periodic Inspection
In the event of an immediate safety hazard, the user must take the lift out of service until the fault is rectified. DEFECTS OR DAMAGE MUST BE REPORTED TO THE MANUFACTURER AUTOLIFT SRL FOR APPROPRIATE ACTION. Pag. 35 di 40... -
Page 36: Demolition And Disposal
POOL LIFT DEMOLITION AND DEVICE i-swim4 DISPOSAL MODEL 10.1 DEMOLITION AND DISPOSAL If the machine is decommissioned, the procedures laid down in current legislation must be followed. In general, it is necessary to disassemble to obtain several groups of homogeneous materials. Special materials such as lubricating oils, electrical/electronic components must be disposed of according to the precise regulations in force. -
Page 37: Spare Parts
POOL LIFT DEVICE SPARE PARTS i-swim4 MODEL 11.1 SPARE PARTS FOR SPARE PARTS CONTACT AUTOLIFT SRL DIRECTLY. Pag. 37 di 40... -
Page 38: Spare Parts
POOL LIFT DEVICE ATTACHMENTS i-swim4 MODEL 12.1 SPARE PARTS EC Declaration of Conformity Spare Parts Request Form. Register of Periodic Inspections. Pag. 38 di 40... - Page 39 FORM FOR SPARE PARTS REQUEST From. SPARE PARTS SERVICE Fax +39 (0)376 553728 CODE TABLE NR DESCRIPTION Q. TY POSITION PRIORITY URGENT NORMAL SHIPMENT PAYMENT DESTINATION SIGNATURE DATE Pag. 39 di 40...
- Page 40 PERIODICAL INSPECTION REGISTER SERIAL I-swim 4 MODEL TYPE OF CONTROL RESULT REMARKS INSPECTION DATE DATE OF NEXT INSPECTION PERFORMER OF INSPECTION SIGNATURE Pag. 40 di 40...
Need help?
Do you have a question about the i-swim 4 and is the answer not in the manual?
Questions and answers