WHEELCHAIR LIFT DEVICE F6 MULTILINK TABLE OF CONTENTS MODEL 11-2019 REVISION DATE GENERAL WARNINGS ..............................5 MANUFACTURER ..............................4 MARKING ................................. 4 IDENTIFICATION OF OPERATORS ........................5 STRUCTURE AND USE OF THE MANUAL ......................6 SAFETY – GENERAL RULES ..........................7 WARRANTY ................................
Page 3
WHEELCHAIR LIFT DEVICE F6 MULTILINK TABLE OF CONTENTS MODEL 11-2019 REVISION DATE HYDRAULIC DIAGRAM .............................. 57 SPARE PARTS ................................58 ANNEXES…………………………………………………………………………..............63...
24 V dc PRESSIONE IDRAULICA 250 bar GRADO DI PROTEZIONE MINIMO IP44 AUTOLIFT srl Via Ferri, 3 46020 Pegognaga (MN) Italy Tel. +39 0376 550375 - info@autolift.com CUSTOMER NAME: INSTALLER NAME: DATE OF INSTALLATION: SERIAL NUMBER: IT IS PROHIBITED TO REMOVE OR TAMPER WITH THE...
WHEELCHAIR LIFT DEVICE F6 MULTILINK GENERAL WARNINGS MODEL 11-2019 REVISION DATE IDENTIFICATION OF OPERATORS The lift user is the physical or legal person who purchases it and has it operated by an operator. The operator, also defined as the accompanying person, is the person who uses the device.
Before performing any operations on the lift, users and operators must carefully read the instructions given in this publication. In the event of any doubt over the correct interpretation of the instructions, contact the AUTOLIFT srl technical department to obtain the required clarifications.
Examine the hydraulic lift carefully before each use. If there are any hazardous conditions or if you notice unusual noises or movements, do not use the lift and contact an Autolift agent or authorised workshop for the necessary inspections and repairs.
Page 8
WHEELCHAIR LIFT DEVICE F6 MULTILINK GENERAL WARNINGS MODEL 11-2019 REVISION DATE Use the lift with the vehicle parked on flat ground, where possible The vehicle must always be parked safely with the emergency brakes on before starting to operate the lift. Make sure that the wheelchair is braked and placed securely on the platform, and that it does not extend over the edge.
Page 9
These checks and adjustments must be performed exclusively by authorised Autolift staff. Take care when driving over roads with large humps or dips since the vehicle ground...
ALWAYS CHECK THAT THE VEHICLE BATTERY IS SUFFICIENTLY CHARGED BEFORE USING THE LIFT. WARRANTY Autolift S.r.l. shall not be held liable for malfunctions caused by a failure to comply with the following instructions: Maintain a suitable distance between the fuel tank and the top cover.
WHEELCHAIR LIFT DEVICE F6 MULTILINK GENERAL DESCRIPTION MODEL 11-2019 REVISION DATE COMPONENTS Stainless-steel housing Flashing movement indicator Bridge plate (rear flap) Push-button panel Jointed drive arms Electrical control unit Aluminium platform Hydraulic power unit Roll stop (front flap) External hydraulic power unit (optional) The drawing shown represents all models...
WHEELCHAIR LIFT DEVICE F6 MULTILINK GENERAL DESCRIPTION MODEL 11-2019 REVISION DATE TECHNICAL DATA Capacity Weight Power supply Volt Max. pressure Platform 760 x 1160 Max. overhang Aux emergency pump Airborne noise Db(A) < 70...
WHEELCHAIR LIFT DEVICE F6 MULTILINK FIELD OF USE MODEL 11-2019 REVISION DATE INTENDED USE The lift is designed for installation on the loading floor of a vehicle designed for transportation of wheelchair users, within the limits of the performance and capacities indicated in the technical characteristics.
WHEELCHAIR LIFT DEVICE F6 MULTILINK SAFETY DEVICES MODEL 11-2019 REVISION DATE HYDRAULIC POWWR UNIT EXTERNAL HYDRAULIC POWER UNIT Overload limit valve Bridge plate (rear flap) Roll stop (front flap) Housing safety electromagnet (inside the rear part of the platform)
WHEELCHAIR LIFT DEVICE F6 MULTILINK WARNING SIGNS MODEL 11-2019 REVISION DATE THE LIFT HAS THE FOLLOWING MARKINGS Read manual before It is forbidden for untrained using the lift persons to operate the lift Risk of crushing IT IS FORBIDDEN TO TAMPER WITH/REMOVE THE MARKINGS.
WHEELCHAIR LIFT DEVICE F6 MULTILINK RESIDUAL RISKS MODEL 11-2019 REVISION DATE Although protective measures have been integrated in the lift design, including supplementary protective measures, the residual risks specified below nevertheless remain. If a person should insert a body part (hand, arm etc.) inside the levers making up each side of the machine during the lift's operation, they expose themselves to a crushing/shearing hazard.
WHEELCHAIR LIFT DEVICE F6 MULTILINK INSTALLATION MODEL 11-2019 REVISION DATE RECEIPT AND INSPECTION On receipt of the lift, you must perform the following inspections: Check that the supplied items correspond to the order specifications and the transport docket. Check that the packaging is intact and that no parts have been broken or damaged during transportation.
WHEELCHAIR LIFT DEVICE F6 MULTILINK INSTALLATION MODEL 11-2019 REVISION DATE TRANSPORT The lift must be transported using a vehicle (van, lorry etc.) of an appropriate size and capacity. The lift is shipped by the manufacturer packed on a europallet measuring 1800 x 1200 mm. The total height of the pallet with the lift is 410 mm.
INSTALLATION ON A VEHICLE Installation on a vehicle must be performed exclusively by authorised installers. Autolift shall bear no liability for injury or damage to property or the machine itself due to installation on a vehicle not performed by authorised persons.
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE NORMAL USE The F6 MULTILINK electro-hydraulic lift control is a wired portable remote control known as push-button control panel, equipped with two rectangular dual-command buttons. There are raised symbols on the buttons corresponding to each of the four control functions. Specific movements of the lift, described below, correspond to each press of a button.
Page 22
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.1.2 HOW TO GET INTO THE VEHICLE Press “OUT” to extract the platform from the housing. Hold the button down until the platform stops automatically; The platform is in the correct position when the graphic indication on the carriage is reached.
Page 23
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.1.3 HOW TO GET OUT OF THE VEHICLE 1. Push Button “Platform Out” to let the platform exit from the cassette. Keep pushing the button platform stops automatically. 2. Press the “Platform Up” button until the platform reaches the vehicle floor level 3.
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE EMERGENCY USE 8.2.1 MANUALLY OPENING THE PLATFORM TWO PEOPLE ARE REQUIRED TO PERFORM THIS OPERATION. The following manoeuvres must be performed in sequence to open the platform manually: A. Turn the nut (1) on the rear of the housing, that is the side opposite the lifting side, by 90°...
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.2.2 EMERGENCY RAISING The following manoeuvres must be performed in sequence to raise the platform manually in an emergency: D. Take the lever (5) supplied E. Screw it down all the way onto the hand pump lever mechanism (6).
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.2.3 EMERGENCY LOWERING The following operations must be performed in sequence to lower the platform manually in an emergency: F. To lower the platform it is necessary to operate on the hydraulic power unit solenoid valve (7).
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.2.4 EMERGENCY LIFT WITH AN EXTERNAL CONTROL UNIT The following manoeuvres must be performed in sequence to raise the platform manually in an emergency: Remove the rubber plug (3). Tighten the lever (5) on the hand pump lever mechanism (6).
WHEELCHAIR LIFT DEVICE F6 MULTILINK MODEL 11-2019 REVISION DATE 8.2.5 EMERGENCY DESCENT WITH AN EXTERNAL CONTROL UNIT The following manoeuvres must be performed in sequence to lower the platform manually in an emergency: Remove the protective plug (7). To lower the platform, operate the solenoid valve on the control unit (8).
Ensure that the platform is locked in the housing by attempting to remove it manually. DO NOT START WITH THE VEHICLE, IF THE SAFETY MAGNETE IS NOT INSERTED AND THE RACK IS NOT ENGAGED. AUTOLIFT SRL IS NOT RESPONSIBLE FOR ACCIDENTS DUE THE NOT OBSERVANCE OF THIS PROCEDURE...
WHEELCHAIR LIFT DEVICE F6 MULTILINK CLEANING MODEL 11-2019 REVISION DATE The lift must be cleaned by hand using a cloth moistened with non-corrosive detergent and then rinsed with a cloth dampened with water. DO NOT USE CORROSIVE DETERGENTS. DO NOT USE WATER JETS OR HOT WATER JET CLEANERS. REGULARLY REMOVE ANY MUD, SNOW, DEBRIS (LEAVES, PAPER ETC.) WHICH MAY BE DEPOSITED ON ANY PART OF THE LIFT.
In the event of an immediate safety hazard, the user must place the lift out of use until the fault has been eliminated. Defects or damages must be reported to the manufacturer AUTOLIFT srl who will take any appropriate measures.
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 10.2 FREQUENCY OF CHECKS Inspection/maintenance every: Operation Every time the lift Months Months Months is used Check the wear of the front seal Check the wear of the plastic guards Make sure the rubber plug of the emergency device on the fixed ...
Page 33
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE Inspection/maintenance every: Operation Every time the lift Months Months Months is used Checking the opening/closing speed of the platform: check the platform opens and closes at a constant speed. IMPORTANT: Changes in the opening speed could be a sign of the platform rubbing against the housing internally Checking the closure of the front flap: after it has closed, check the...
Page 34
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 1. Cleaning the platform 2. Cleaning and greasing the front flap...
Page 35
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 3. Cleaning inside the housing 4. Checking oil level in the hydraulic control unit...
Page 36
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 15 mm 5. Checking the screws are tight using a torque wrench...
Page 38
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 6. Cleaning and greasing rank and the pinion 8. Cleaning and greasing the guide carriage, carriage bearings and head of the tension rod screws...
Page 39
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 9. Checking the movement of the bridge plate 10. Checking the level of the platform Same height 12. Checking the closure of the front flap...
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 10.3 TOPPING UP AND DRAINING THE HYDRAULIC CONTROL UNIT 1) Before starting repairs or replacements, lower the platform down completely and open the front flap completely. 2) After completing the repair, keep the platform completely lowered down and the flap completely open, unscrew the cap and check oil level is about 15mm below the topping up hole.
Page 41
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 15 mm If this is not the case, top up with HDZ 15 oil to the correct level 15 mm 3) Hand pump with the lever in order to fill the pump with oil.
Page 42
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 4) Use the lift button to raise the vehicle to its maximum position LIFT...
Page 43
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 5) Press the down button: wait for the platform to lower completely and open the front flap. IMPORTANT: PRESS AND HOLD THE BUTTON FOR 30 SECONDS AFTER THE FLAP HAS OPENED COMPLETELY...
Page 44
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE LOWER 6) Repeat steps 4 and 5 four times 7) Top up with HDZ15 oil until it is 15mm below the topping up hole...
Page 45
WHEELCHAIR LIFT DEVICE F6 MULTILINK MAINTENANCE MODEL 11-2019 REVISION DATE 15 mm 8) Replace the cap.
WHEELCHAIR LIFT DEVICE DEMOLITION AND F6 MULTILINK DISPOSAL MODEL 11-2019 REVISION DATE When disposing of the machine, comply with the procedures set out in applicable legislation. Generally the machine should be disassembled to group similar materials together. Specific materials such as lubricants and electrical / electronic components must be disposed of according to specific laws.
WHEELCHAIR LIFT DEVICE F6 MULTILINK TROUBLESHOOTING MODEL 11-2019 REVISION DATE The troubleshooting table below helps to rapidly solve any operating faults. For any malfunctions that are not listed below or are due to mechanical and/or hydraulic breakages, contact your nearest authorised service centre. ANOMALY CAUSE REMEDY...
Page 56
WHEELCHAIR LIFT DEVICE F6 MULTILINK HYDRAULIC DIAGRAM MODEL 11-2019 REVISION DATE KEY TO SYMBOLS AP05/0.5 Pump SDFE817/22 Directional valve solenoid Electric motor PM817 Manual emergency pump 230 bar PSV Adjustable flow limiter Test valve Intake filter...
Page 57
WHEELCHAIR LIFT DEVICE F6 MULTILINK SPARE PARTS MODEL 11-2019 REVISION DATE For spare parts, contact the Autolift Srl spare parts department by submitting the following form. N° DESCRIZIONE CODICE POSIZIONE Front casing F6000444 Seals F6000958 Roll stop F6002661-AN Lower cover with reinforcement...
Page 58
WHEELCHAIR LIFT DEVICE F6 MULTILINK SPARE PARTS MODEL 11-2019 REVISION DATE Plastic slide bridge plate F6000535 Front platform plate F6002655 Right rear platform plate F6000591-CR Left rear platform plate F6000594-CR Bridge plate F6002605-AN Buffer bridge plate F6000152 Kit for moving bridge plate K1002045 Safety magnet F6000981...
Page 59
WHEELCHAIR LIFT DEVICE F6 MULTILINK SPARE PARTS MODEL 11-2019 REVISION DATE...
Page 60
WHEELCHAIR LIFT DEVICE F6 MULTILINK SPARE PARTS MODEL 11-2019 REVISION DATE...
Page 61
WHEELCHAIR LIFT DEVICE F6 MULTILINK SPARE PARTS MODEL 11-2019 REVISION DATE 35 35...
Page 62
WHEELCHAIR LIFT DEVICE F6 MULTILINK ANNEXES MODEL 11-2019 REVISION DATE • SPARE PARTS REQUEST FORM • PERIODIC LIFT INSPECTION REGISTER...
Page 63
SPARE PARTS REQUEST FORM FROM SPARE PARTS DEPARTMENT Fax +39 0376 553728 CODE DESCRIPTION DWG. POSITION PRIORITY URGENT NORMAL SHIPMENT PAYMENT DESTINATION SIGNATURE DATE...
Page 64
Periodic lift inspection register Model F6 multilink Serial no. INSPECTION TYPE OUTCOME NOTES INSPECTION DATE DATE OF NEXT INSPECTION IDENTIFICATION OF THE PERSON SIGNATURE PERFORMING THE INSPECTION...
Need help?
Do you have a question about the MULTILINK F6EVO and is the answer not in the manual?
Questions and answers