Setting The Clock; Setting The Timer - Aiwa NSX-A94 Operating Instructions Manual

f
SETTING THE CLOCK
SETTING THE TIMER
,
I t
Press the CLOCK button on the remote control,
The unit can be turned on at a specified time every day with the
and prqss the 11 SET button within 4 seconds.
built-in timer.
\. y,
$ "'
?-'-48
"USS;*+YSW,VAW3S4%-V,:$
., ,*,
n
",p:$~Ba3)j,@&~g
~, ,,,:'., -j,
(-.; ~-~
-w
i6&8g&kk8fg
wkBwwB$
Preparation
14PJRE:::Z:!:;;:<8
gigkJ=# & &+" ,a,r = ,,==
" 4 i =$jg~lEm5&s,,,a.Q'~=%wE*%E#%3
;'; '":x%&&*& Make sure the clock is set correctly.
?hq$f$;q : ' '
't::::~~aB~~'b&g:@=i,.r&.e..... ---
:.!!$~*=.;~k&=.~#~~:% *.8=,1::;:;
~~ ~~~', E !%~@+qrL**~B~,~ap:8t&p$.~+>e&4
ia@,r_8w.&dEiwi@&$
Use the remote control.
2 Press the - DOWN or > UP button to
7 .Press the TIMER button once to display @), and
designate the hour, and press the 11 SET button.
press the 11 SET button within 4 seconds.
The hour stops flashing and the minute starts flashing.
0 is displayed, and the hour flashes.
3 Press the + DOWN or PP UP button to
designate the minute, and press the II SET
button.
The minute stops flashing on the display and the clock,starts
from 00 seconds.
o
,.
To display the current time
m
Press the CLOCK button on the remote control. The time is
If you press the II SET button after 4 seconds, another
displayed for 4 seconds.
operation may start.
However, the time cannot be displayed during recording.
2
Designate the hour of the timer-on 'time by
To switch to the 24-hour standard
pressing the * DOWN-or
-'UP button, and.
Press the CLOCK button on the remote con~ol and then press
press the II SET button. Repeat to designate the
the button within 4 seconds.
minute of the timer-on time.
Repeat the same p[ocedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
After you designate the timer-on time, one of the source name
all settings stored'in memory after purchase need to be reset.
flashes on the display for 4 seconds.
3 Within 4 seconds, press one of the function .
buttons to select a source.
The selected source name flashes for 4 seconds. At this time,
the selected function button does not light up.
If this step is not completed within 4 seconds, repeat from
,.
step 1.
If the TUNER button is pressed, the band cannot.be selected
in this step. .
4 Within 4 seconds, select the duration for the
timer-activated period with the 1+ DOWN or FFl
UP button.
,;
->
,,
21
@/G&/