Setting The Clock - Aiwa XR-M7 Operating Instructions Manual

oe
4 TUNING
144 DOWN
UPP PT
PREPARATIONS
SETTING THE CLOCK
When the AC cord is connected for the first time, the Il SET
button flashes.
Set the time as follows while the power is off.
1 Press the Il SET button.
The hour flashes.
2 Press the << DOWN or UP P button to
designate the hour. '
3 Press the Il SET button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the << DOWN or UP P button to
designate the minute,
5 Press the Il SET button to set the minute and
complete setting.
The minute siops flashing on the display and the clock starts
from 00 second,
To correct the current time
Press the POWER button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To display the current time .
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press
the Ml button within 4 seconds,
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.