D-Link DES-3326S User Manual page 65

DES-3326S Layer 3 Fast Ethernet Switch User's Guide
When STP is enabled, every port on every switch in the network
goes through the blocking state and then transitions through
the states of listening and learning at power up. If properly
configured, each port stabilizes to the forwarding or blocking
state.
No packets (except BPDUs) are forwarded from, or received by,
STP enabled ports until the forwarding state is enabled for that
port.
Default Spanning-Tree Configuration
Feature
Enable state
Port priority
Port cost
Bridge Priority
User-Changeable STA Parameters
The factory default setting should cover the majority of
installations.
settings as set at the factory; unless, it is absolutely necessary.
The user changeable parameters in the Switch are as follows:
•
Priority A Priority for the switch can be set from 0
to 65535. 0 is equal to the highest Priority.
•
Hello Time
seconds.
Switch Management and Operating Concepts
Table 5-7. Default STP Parameters
However, it is advisable to keep the default
The Hello Time can be from 1 to 10
This is
Default Value
STP enabled for all ports
128
19
32,768
the interval between two
65