DES-3326 Layer 3 Fast Ethernet Switch User's Guide
•
From forwarding to disabled
•
From disabled to blocking
When STP is enabled, every port on every switch in the network goes through the blocking state and
then transitions through the states of listening and learning at power up. If properly configured, each
port stabilizes to the forwarding or blocking state.
No packets (except BPDUs) are forwarded from, or received by, STP enabled ports until the forwarding
state is enabled for that port.
Default Spanning-Tree Configuration
Figure 5-3. STP Port State Transitions
Feature
Enable state
Port priority
Port cost
Bridge Priority
Table 5-3. Default STP Parameters
Default Value
STP enabled for all ports
128
19
32,768
33