Extending The Cooling Down Time - Miele T 234 C Operating Instructions Manual

Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to
handle.
The dryer is delivered with the
extended cooling down time option
deactivated. You can extend the
cooling down time by 5 minutes or 10
minutes.
The option of extending the cooling
down time is available with the Cottons,
Minimum iron and Automatic
programmes.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is at Finish .
A Press the Start button and keep it
pressed in whilst carrying out steps
B-C.
B Switch the dryer on with the
I-On/0-Off button.
C Wait until the Start indicator lamp
comes on . . .
D . . . and then release the Start button.
E Turn the programme selector to the
Cottons Machine iron position.
F Pressing the Start button alters the
cooling down time.
Programmable functions
– If the Drying indicator lamp flashes
once:
The cooling down time will be five
miinutes longer.
– If the Drying indicator lamp flashes
twice:
The cooling down time will be ten
minutes longer.
– If the Drying indicator lamp is not
flashing:
The cooling down time is not
extended.
G Switch the machine off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check:
^ Make sure the dryer is switched off,
the door is closed and the
programme selector is at Finish and
then carry out steps A to E.
The Drying indicator lamp will show you
if the cooling down time has been
extended.
^ Switch off the dryer.
The check is complete.
41