Related Manuals for Miele T 4222 C
Summary of Contents for Miele T 4222 C
- Page 1 Operating instructions for condenser tumble dryer T 4222 C To avoid the risk of accidents or damage to the machine it is to read these operating instructions before it is installed or used for the first time. M.-Nr. 06 067 730...
- Page 2 ........4 ......... . 7 Disposal of the packing material .
- Page 3 ..........22 General problems .
- Page 4 This machine is not a toy! To avoid liability. Repairs should only be the risk of injury, do not allow undertaken by a Miele approved children to play on or near it, or to technician. play with the controls. Supervise its Ensure current is not supplied to the use by the elderly or infirm.
- Page 5 If the connection cable is faulty it the pump, hoses and / or condensed must only be replaced by a Miele water container. approved service technician to protect If the water is drained externally the user from danger. through the drain hose instead of...
- Page 6 Accessory parts may only be fitted when expressly approved by Miele. If non-Miele parts are used with this – fabrics which contain a large machine, guarantee, performance and proportion of rubber, foam rubber or product liability claims may be rubber like materials.
- Page 7 It should be unplugged or disconnected from the mains electricity supply by a competent person. The plug must be The transport and protective packing rendered useless and the cable cut off has been selected from materials which directly behind it to prevent misuse. are environmentally friendly for disposal See the "Warning and Safety"...
- Page 8 d I-On/0-Off The programme selector can be To switch the machine on or off / to turned clockwise or anti-clockwise. interrupt a programme. e Door To open the door / to cancel a c Start programme. Pressing this button will open the Press the Start button to start a door even when the machine is programme.
- Page 9 Items filled with down. The fabric lining on these garments Before drying check the drying may shrink depending on the quality. symbol on the wash care label. They can be partially dried using the Smoothing programme. Significance of symbols: Pure linen should only be machine q Dry at normal temperature dried if specified as suitable by the r Dry at low temperature...
- Page 10 maximum load: 5 kg Drying levels Single and multi-layered fabrics, e.g. mixed load of cotton fabrics (e.g. towelling, jerseywear). Load of similar cotton If laundry is still too damp, fabrics (jersey wear, then: flannelette sheets, - finish drying using Timed towelling).
- Page 11 maximum load: 2.5 kg Drying levels Minimum iron items which Spin minimum iron fabrics are made of synthetic or for at least 30 seconds in the blended fabrics (e.g. washing machine before pullovers, dresses, trousers) drying them. which are not dried adequately in the Normal programme.
- Page 12 maximum load: 2 kg Woollen fabrics To refresh and fluff up woollen garments quickly. Remove garments immediately at the end of the programme. Do not repeat. Woollen fabrics are not dried completely by this programme. maximum load: 2.5 kg Cottons and linen fabrics. Smooths out creasing caused during Minimum iron items made the spin cycle in the washing...
- Page 13 Do not overload the drum. ^ As far as possible, sort laundry for: Overloading can cause unnecessary - the type of fibre or weave, wear and tear to the laundry and - the degree of dryness required, give a disappointing drying result. - similar size of items, - the moisture content after See the "Programme chart"...
- Page 14 ^ Press the Start button. The drying cycle begins. The drying stage reached is shown by the sequence indicator lamps on the right hand side of the control panel. At the end of the drying phase a cooling down phase commences to cool the laundry down.
-
Page 15: Adding Or Removing Items
The programme has been successfully cancelled when only the Anti-crease/ As long as the cooling down phase or Finish indicator lamp is on. the anti-crease phase has not been reached it is possible to change a programme after it has started by turning the programme selector to a At the end of a programme the Anti- different programme position. - Page 16 The condensed water will be collected in the condensed water container unless the machine has been fitted with a drain hose (see installation). The condensed water container should be emptied or as soon as the Empty out container indicator lamp comes on.
- Page 17 The fluff which is created by the drying is available as an optional extra from process is collected by the fluff filters in your Miele dealer or the Miele Spare the door and the door opening. Clean Parts Department. the filters after drying programme.
- Page 18 ^ Dry all parts with a soft cloth. ^ Rinse the filters under hot, running ^ A microfibre E-Cloth is available from water. the Miele UK Spare Parts Department which is suitable for cleaning ^ Then shake the filters until no more surfaces such as stainless steel, water droplets are visible.
- Page 19 Detergent residue, hair and fine fluff from the dryer can get through the fluff filters and block the condenser unit. Dust from the room in which the dryer is installed can also get into the condenser unit and cause a blockage. the condenser unit at least twice a year.
- Page 20 If you cannot see any fluff: ^ Replace the condenser unit (see following page). If you can see some fluff: ^ Clean the condenser unit as described below. ^ Pull the condenser unit out of its housing by the handle. ^ Use a shower head or similar to rinse the unit out ^ Hold the condenser unit up to the...
- Page 21 ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove.
-
Page 22: Repairs
With the help of the following notes minor faults in the performance of the machine, some of which may result from incorrect operation, can be put right without contacting the Service Department. Repair work to electrical equipment should only be carried out by a suitably qualified person in accordance with local and national safety regulations. - Page 23 Fluff is principally the result Fluff is collected by the fluff of friction when garments filters and can be easily are being worn and removed (see "Cleaning washed. Machine drying and Care"). hardly causes any fluff to form and has been established by research institutes to have no effect on the lifetime of fabric.
- Page 24 : Before attempting to remedy one of the following causes, switch the dryer off and switch on again to start the programme again. Ventilation to and from the Open a door or window dryer may be insufficient while the machine is in (e.g because it is installed in operation for increased air a small room).
- Page 25 – Switch off the dryer. cause. – Then switch the dryer back on and start the programme Hand iron Machine again. iron If the programme stops again and an indicator lamp flashes, there is a fault. Contact the Miele Service Department.
- Page 26 This is not a fault. Use the "Timed drying - Anti- Warm air" programme to The electronic unit has crease/Finish dry individual items. recognised that there is no laundry in the drum Before changing a and cancelled the programme: Open and programme.
- Page 27 ^ Turn your wrist to make the cover open downwards. The temperature resistant lamp should only be ordered from your Miele dealer or the Miele Spare Parts Department. The lamp must not exceed the maximum wattage quoted on the data plate and on the lamp cover.
-
Page 28: Optional Accessories
– The Miele Service Department (see back cover for address). Optional accessories for these dryers When contacting the Service are available from your Miele Dealer or Department, please quote the model from the Miele Spare Parts Department. and serial number of your machine,... - Page 29 a Mains connection cable e Service panel for condenser unit b Condensed water container f Four height-adjustable screw feet c Control panel g External drainage options (e.g. via wash basin, wash basin drain outlet, d Door or gully).
- Page 30 * Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department. The dryer should not be installed The building under kit is supplied with next to a refrigerator or freezer.
- Page 31 (WTV) to match your washing machine is required. * Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department. Stacking kits must be fitted by a suitably qualified fitter. After each use a small quantity of...
-
Page 32: Front View
If it is not long enough, an extension hose is available as an optional (See illustration). Important: accessory through your dealer or from the Miele Spare Parts Dept. Do not let the drain hose become kinked, as this could damage it. - Page 33 If this nut has a flat disc sealing it you should take the disc out first. The drain hose can be connected Important: if this nut has a washer or directly to a sink drain outlet. seal in it this must not be removed! ^ Attach the end of the hose to adapter ^ Use a screwdriver to tighten hose clip...
- Page 34 All electrical work should be carried out The fuse cover must be refitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person, in strict accordance with is lost, the plug must not be used until a national and local safety regulations.
- Page 35 Minutes 1200 2.80 1400 2.65 1600 2.40 1800 2.35 800 (70 % residual moisture) 3.40 1200 2.65 1400 2.55 1600 2.25 1800 2.20 800 (70 % residual moisture) 2.75 1200 2.00 1400 1.90 1600 1.60 1800 1.55 1200 1.60 1400 1.50 1600 1.20...
- Page 36 Height 85 cm (adjustable +0.7/- 0.7 cm) Height without lid 82 cm Width 59.5 cm Depth 58 cm Depth with door open 106 cm Weight 54 kg Drum volume 100 litres Maximum capacity 5 kg dry weight Capacity of condensed water container approx.
- Page 37 Programmable functions for changing standard settings...
- Page 38 E Turn the programme selector to the COTTONS Normal position. – If the Drying indicator lamp is not on, The machine is designed to dry the increased drying level using as little energy as possible. However, if you require the laundry to –...
- Page 39 E Turn the programme selector to the COTTONS Low Temperature position. The machine is designed to dry – If the Drying indicator lamp is not on, using as little energy as possible. the increased drying level However, if you require the laundry to be drier, it is possible to reduce the –...
-
Page 40: Buzzer
E Turn the programme selector to the COTTONS Hand iron position. An audible tone sounds repeatedly at – If the Drying lamp is flashing, the the end of a programme. buzzer The buzzer is activated as standard ex- – If the Drying lamp is not on, the works. - Page 44 Alteration rights reserved/3804 M.-Nr. 06 067 730 / 01 en - GB...