Safety Lock (Child Safety Lock; Setting The Temperature; Changing The Temperature Unit - Hanseatic HWC46ECIA User Manual

Switching off
• Press the key (9).
The temperature indicator
shut off.
The compressor will not work and the ap-
pliance will stop cooling. The appliance is
switched off.

Safety lock (child safety lock)

The appliance is equipped with a safety lock.
When this is activated, no settings can be
changed.
• To activate the safety lock press the but-
tons (9) and (10) at the same time.
A beep will sound. The safety lock is now
activated.
• To deactivate the safety lock again press
the buttons (9) and
same time.
A beep will sound. The safety lock is now
deactivated.

Setting the temperature

WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).
Select an internal temperature to suit the
wine. Further information on the optimum
storage temperature can be found in the sec-
tion "Maintaining quality" on page EN-16.
You can set the appliance to a temperature
from +5 °C to +22 °C (41 °F to 72 °F).
The temperature for the lower range can only
be set equal to or higher than the temperature
in the upper range.
(12) will
1. Select the desired interior zone by press-
2. The temperature of the selected zone can be
(10) at the
This increases the energy consumption.

Changing the temperature unit

You can choose whether the internal temper-
ature is displayed in Celsius or in Fahrenheit.
The small green symbol on the top right next
to the temperature indicator
you identify the current setting.
• To change the unit, press the
Operation
ing the key (11)
– once for the upper zone. The left-hand
temperature indicator (12) will flash.
– twice for the lower zone.
The right-hand temperature indicator
(12) will flash.
As long as the temperature indicator is
flashing, you can set the temperature.
– increased by pressing the
until the desired temperature is dis-
played.
– reduced by pressing the
the desired temperature is displayed.
After a short while the flashing will stop and
the desired temperature will be set.
The appliance will adjust itself to the set
temperature while showing the current in-
ternal temperature.
If you set a lower temperature, you
will need higher cooling performance.
Page EN-13
key (13)
key (14) until
(12) lets
key (15).
C
F