Hanseatic HWC46ECIA User Manual page 39

Page EN-8 Safety
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).
Risk of injury!
Improper handling of the appliance
may result in injury.
The appliance is heavy and bulky.
■
Seek the help of another person when
moving the appliance and changing
the door hinges.
Check that entry route and instal-
■
lation location are free of obstacles
(e.g. closed doors or objects lying on
the floor).
Wear protective gloves when moving/
■
installing the appliance and chang-
ing the door hinges.
Bases, doors, etc. must not be used as
■
steps or for support purposes.
Do not place any heavy objects on
■
the appliance.
When laying the mains cord, take
■
care to prevent the risk of tripping.
Risk of damage
NOTICE
If the appliance has been transported
horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Do not tilt the appliance more than
■
45° or lay it on its side.
Allow the cooling unit to stand up-
■
right for two hours before start-up.
The lubricant will flow back into the
compressor during this time.
Improper handling of the appliance
can lead to damage to property.
Do not use the door to pull or lift the
■
appliance.
The appliance must only be placed
■
on a level and firm surface. The sur-
face must be strong enough to sup-
port the appliance's weight when ful-
ly laden.
Do not operate the appliance near
■
sinks, taps or containers filled with
liquids such as vases, aquariums, etc.
Make sure that the appliance does
not get wet.
Make sure that the ventilation slots
■
are not covered.
The maximum load of 16 bottles per
■
bottle shelf must not be exceeded.
Do not use sharp or pointed objects
■
to unpack it.
Do not use any electrical parts inside
■
the appliance that do not conform to
the manufacturer's recommended
design.
Do not use mechanical devices or oth-
■
er means to accelerate the defrost-
ing process, other than those recom-
mended by the manufacturer.