HUSKY LINERS X-ACT CONTOUR 5311 Care And Use Instructions

CARE AND USE INSTRUCTIONS – PN:5311
Thank you for selecting X-act Contour™ Front Floor Liners from Husky Liners Inc. Your new
front floor liners are custom molded to fit your specific vehicle's floor board. The liners are made to take
the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats
before installing your new floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and
durable. The easiest way to clean your liners is with a damp cloth or sponge and soap and water.
Windex®, 409® and ArmorAll® type cleaners work as well.
LEFT OR DRIVER
PLEASE NOTE THAT THE DRIVER'S SIDE FLOOR LINER ATTACHES TO THE FACTORY FLOOR MAT
RETAINING POSTS LOCATED IN THE DRIVER'S SIDE CARPETING. TO SECURE THE LINER TO THE
POSTS, SIMPLY INSTALL THE LINER AND PUSH IT DOWN TO SEAT IT ONTO THE FACTORY POSTS.
INCLUDED IN THE PACKAGING WITH THE LINERS IS A RETENTION POST THAT CAN BE INSTALLED IN
THE PASSENGER SIDE CARPETING TO AID IN FURTHER RETAINING THE LINER IN PLACE. PLEASE
REFER TO THE BACK OF THIS PAGE FOR DETAILED INSTRUCTIONS ON INSTALLING THIS POST.
IF YOU HAVE VINYL FLOORING, BEFORE INSTALLING THE LINERS PLEASE CLEAN THE FLOOR WELL,
REMOVING ALL DIRT AND DEBRIS.THEN, WIPE THE SURFACE WITH A DEGREASING CLEANSER LIKE
SIMPLE GREEN OR FORMULA 409. THE RUBBERY MATERIAL WILL GRIP THE VINYL FLOOR WELL.
X-ACT CONTOUR
FLOOR LINERS
RIGHT OR PASSENGER
5311_Installation Instructions. R1