HUSKY LINERS X-ACT CONTOUR Care And Use Instructions

CARE AND USE INSTRUCTIONS – PN: 53608
Thank you for selecting X-act Contour™ Front Floor Liners from Husky Liners Inc. Your new
front floor liners are custom molded to fit your specific vehicle's floor board. The liners are made to take
the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats
before installing your new floor liners. However, do not remove the factory-installed carpeting.
When installing your driver's side floor liner make sure that the floor mat retention hook on your
vehicles floor board installs thru the retention hole in your floor liner. See the "Left or Driver" image
below.
Your liners are made from an engineering resin that is lightweight and extremely tough and
durable. The easiest way to clean your liners is with a damp cloth or sponge and soap and water.
Windex®, 409® and ArmorAll® type cleaners work as well.
LEFT OR DRIVER
OPT. KICK
PANEL TRIM
In 2016 Ram modified some HD diesel models requiring a trim out as shown above for proper fit. Test fit your new floor
liner prior to any trimming. A trim guide has been molded in to the backside of the part to assist in trimming. A utility knife
or scissors work well to trim this area.
X-ACT CONTOUR
FLOOR LINERS
CARPET HOOK FLOOR LINER
RETENTION POINTS
RIGHT OR PASSENGER
53608_Installation Instructions. R2
53608