Richmar HydraTherm Deluxe Quick Start Manual

HydraTherm Deluxe
QUICK-START GUIDE
Thank you for purchasing the HydraTherm Deluxe. This Quick-Start Guide will help you to get
started quickly, but does not replace the Operating Manual. Be sure to read, understand, and
practice the operating instructions, warnings, and cautions included in the manual.
INITIAL SET-UP
• Clip shelves onto dividers, then place dividers in tank
and arrange packs as desired. See illustrations below
for recommendation on how to maximize space for
use with 12 packs.
•
Find drain hose in rear of device. Ensure the valve
is closed (turned perpendicular to the hose) before
filling the device with water.
FILLING WITH WATER
• To fill the device, first pour in 3 cups of tap water, followed
by up to 12 gallons of distilled water, stopping when the
water level has reached 2" from the top of the tank.
NOTE: Exact amount of distilled water varies depending
on quantity of packs being used.
NOTE: Distilled water helps to maintain a clean device.
We highly recommend the use of distilled water. Not
using distilled water may cause the unit to require more
cleanings or could cause damage to your unit.
• Caution
Adding additional packs after unit is filled will cause
water to displace and may cause an overflow condition.
Clip
POWERING ON THE DEVICE
•
Ensure power switch on back of device is in the
OFF position.
•
Connect the included power plug into the rear of the
device, and then into the nearest available outlet.
•
Ensure the Heat/Drain switch on the rear of the device is
toggled to HEAT.
•
Toggle the power switch to the ON position.
When powered on, the power switch will illuminate, and
the digital display on the front of the device will display
the current water temperature.