Page 1
Pet Grooming Kit User Manual • Uživatelský manuál • Užívateľský manuál • Használati utasítás...
Page 2
Please read the user instruction carefully prior to product use and keep it in a safe place. Reminder Before use 1. Press the PUSH button on the front side of the dust cup. 2. After the dust cup is lifted slightly, it can be removed. 3.
Page 3
Air inlet Functional Parts Electric clipper x Grooming brush Deshedding Paw trimmer x1 Crevice tool x 1 (Including body brush x 1 fur trimmer) Accessories Electric clipper comb Hepa filter screen Electric clipper TYPE- Cotton filter x 2 attachments x 4 C Charging cable x 1...
Page 4
Soft hose x 1 Storage bag x 1 Product Installation Dust cup installation 1. Align the dust cup buckle with the main device slot. 2. Press end of the dust cup until heard a “click” sound, which means the installation is successful.
Page 5
Functional parts installation and removal Following picture uses electric clippers as an example, and the installation method of other functional parts is the same) 1. Functional parts installation: Insert the hose connector into the functional part and fasten tightly. 2. Functional part removal: Press the button on the hose lightly to remove the functional part.
Page 6
Product Use Turn on device and mode selection 1. Insert power cable, press On/Off button to start the device. On/Off button On/Off: Short press Suction switch button Suction switch: short press 2. 3 suction level to select Level 1 Level 2 Level 3 Note: This product has a voltage error protection setting, when the indicators flash at the same time, and there is a “drip”...
Page 7
On/Off button Flashing Require red light charging Battery indicator light Red light is (working state) Charging active Battery has No light Type-C run out charge port Battery indicator light (working state) Three blue lights are on Full battery state Two blue lights are on Medium battery state One blue light is on Low battery state...
Page 8
Replacement of trimmer Turn the attachment counterclockwise to the end and take it out upwards. Vertically install the replacement attachment at an angle of 45° and rotate it clockwise to the end. Electric trimmer use instructions Note: Remember to pay attention to the clipper edge and sharp position during use, and don’t use excessive force to avoid skin scratches.
Page 9
Paw trimmer: trimming fur around feet, eyes and ears. Grooming brush Can clean the remaining loose fur and dandruff on the pet’s body, and also pulls the fur, making the fur more fluffy. 1. Press the HOLD button and push it forward to the end, then push the HOLD button downward to complete the locking before start use.
Page 10
3. When the Grooming brush accumulates a certain amount of fur, push the HOLD button up to unlock the comb, and push it forward repeatedly until the fur is sucked into the dust cup. Push back and forth Unlocked state comb needles retract, can be pushed forward repeatedly...
Page 11
3. When the Deshedding brush accumulates a certain amount of fur, push the HOLD button up to unlock the comp, and push it forward repeatedly until the fur is sucked into the dust cup. Push back and forth Unlocked state comb needles restract, can be pushed forward...
Page 12
2. After opening the dust cup lid, remove the fur and clean the dust cup. 3. Align the dust cup buckle with the slot of the main device and press the end of the dust cup. After heard a “click” sound, the installation is successful. Electric clipper cleaning 1.
Page 13
2. Turn the device, use the hose to suck off the residual hair on the body fur trimmer, body fur clipper holder, Paw trimmer and electric clipper main body. Body fur clipper Body fur trimmer blade Electric clipper body Paw trimmer holder (The above picture takes the body fur trimmer blade as an example, and the cleaning method of other parts is the same)
Page 14
2. Rinse the filter cotton in cold water and wring it out. 3. Place in a ventilated place to dry for more than 24 hours until completely dry. 4. Place the dried filter cotton back on the cup. Note: The filter cotton should be washed regularly with cold water.
Page 15
2. Rinse the Hepa filter screen with cold water and dry it after washing. 3. Place in a well-ventilated area to dry for over 24 hours until completely dry. 4. Install the dried Hepa filter screen back Note: the front is facing outward (the lettering is on the front) Note: ...
Page 16
Thank you for purchasing PET GROOMING KIT (PETKIT AIRCLIPPER 5-in-1). We at PETKIT have done our best to make life easier for you and your pets with technology. Please carefully read the User Manual before using the product. By setting up and using this product, you are acknowledged that you have already ready and accepted the safety guidelines listed below.
Page 17
User Safety Guide Failure to follow the safety guides outlined below result in product malfunction, or other accidental losses. This device is only suitable for indoor use in a dry environment, do not use it on wet ground. Please place the device on a hard and flat surface for use, and do not place on a soft and uneven object to prevent the device from falling.
Page 18
The device has been approved for use in EU countries and is therefore provided with the CE All necessary documentation is available on the website: www.electric-collars.com mark. Changes to technical parameters, properties and printing errors reserved. Service center and distribution Reedog, sro Sedmidomky 459/8 101 00 Prague 10...
Need help?
Do you have a question about the AIRCLIPPER and is the answer not in the manual?
Questions and answers